ARIZER AIR (01) PDF Document

The ARIZER AIR includes the following items:

1 warming unit

1 charge cord

2 glass stems (one with a plastic mouthpiece)

1 carrying case

1 clear protective silicone skin

1 stainless steel stirring tool

2 silicone stem caps

Follow these steps when using your new ARIZER AIR for the first time:

Look over all the parts included to ensure they are in good condition.

Charge the battery completely before using for the first time.

Warm the unit to the hottest temperature setting before inserting a glass stem. This will make inserting the glass stem easier and will be necessary the first few times. After a few uses, there will be less resistance when inserting the glass stem.

When charging the ARIZER AIR, please note the following LED indicators and guidelines:

Low Battery: The lower LED light glows solid red.

Charging: The light flashes green while charging.

Fully Charged: The light glows solid green when the battery is fully charged.

Only use the charger supplied by the manufacturer.

Protections built into the unit prevent overcharging, so it can safely be left plugged in even after it is fully charged.

To ensure optimal performance of the ARIZER AIR, follow these cleaning instructions:

Use the included stainless steel tool to remove material left in the glass stem and heating unit after use.

Remove the plastic mouthpiece from the glass stem.

Soak both the glass stem and plastic mouthpiece in isopropyl alcohol or dish soap.

If using alcohol, soak the plastic mouthpiece for no more than 30 minutes.

Rinse with hot water and repeat as necessary.

To operate the ARIZER AIR power and heat settings:

Power On/Off: Hold both temperature control buttons for three seconds.

Select Temperature: Use the Up (Hotter) or Down (Cooler) buttons to choose your desired setting.

Heating Indicator: The temperature is reached when the blue light glows solid. This typically takes 1 to 2 minutes.

The ARIZER AIR features five temperature settings indicated by different colors:

Follow these steps to prepare and use the ARIZER AIR:

Load the herb chamber with medium- to coarse-ground herbs. The approximate capacity is 0.5 grams. Do not pack too tightly.

Insert the glass stem completely into the unit.

Wait for the blue light to glow solid, indicating the temperature is reached.

Draw vapor into the lungs.

Hold in the lungs for as long as you are comfortable, then exhale.

Please observe the following safety warnings for the ARIZER AIR:

The heating area and glass stem become hot during use. Keep fingers and other items away from the heating area.

Allow at least five minutes after use for the unit to cool before handling or packing away. Do not leave the unit unattended while it is heating.

Avoid impacts with hard surfaces and extreme changes in temperature for the borosilicate glass stems. Do not use a stem if it is broken, cracked, or damaged.

Do not immerse the unit in liquid, pour anything into the unit, or open the unit, as it contains delicate electrical parts.

Keep the unit and parts out of reach of children, minors, and pets due to choking and burning risks.

To safely manage the ARIZER AIR lithium battery:

Avoid dropping the battery and do not tamper with it or use it if damaged.

Always match negative (-) and positive (+) terminals correctly when inserting the battery.

Only use chargers and batteries supplied by the manufacturer.

Store batteries in a cool, dry place.

Do not store batteries that are either fully charged or fully drained for more than one month.

When disposing of the battery, place it in a box marked lithium battery and hand it to a chemical waste disposal facility.