ARCSOUND NOVA (01) PDF Document

For your safety and to ensure optimal performance of the ARCSOUND NOVA, please observe the following precautions:

Battery Lifespan Protection: To maintain the battery’s health, ensure that you fully charge the NOVA at least once every 3 months. Keep in mind that battery life may vary based on usage patterns and environmental factors.

IPX6 Rating – Waterproof and Dustproof: The NOVA is rated IPX6 for water and dust resistance, meaning it can withstand 100 liters of water sprayed onto it for 3 minutes at a pressure of 100 kPa.

Liquid Exposure Warning: Never expose the NOVA to liquids while it’s connected to a cable. Additionally, avoid getting the speaker wet while charging, as this could result in permanent damage to both the speaker and its power source.

Impact of Chemicals and Saltwater: Exposure to chemicals and salt from pool or ocean water can weaken the waterproof seals and damage the connector surface over time. Always rinse the NOVA with fresh water after exposure to these elements to prevent damage.

Charging After Liquid Exposure: If the NOVA has been exposed to liquid, allow it to dry completely and ensure it is clean before charging. Charging while the speaker is wet could cause irreversible damage.

External Adapter Compatibility: When using an external adapter, ensure that the output voltage and current do not exceed 5V/3A to avoid damaging the speaker.

The package for the ARCSOUND NOVA includes the following items:

Bluetooth speaker

Quick start manual

USB-C charging cable

Power On/Off: Hold the Power button for 3 seconds to turn the speaker on or off.

Volume: The default volume is set to 30% when the speaker is turned on. Use the + and – buttons to adjust.

Skip Tracks: To skip to the next or previous song, press and hold the + or – button.

Disconnect Bluetooth: Press and hold the Play/Pause button to disconnect Bluetooth.

Automatic Power Off: The speaker will automatically power off if it is not used for more than 20 minutes.

1. Hold the Power button for 3 seconds to power on the ARCSOUND NOVA.

2. Choose Bluetooth mode by pressing the On / Off button.

3. Open the Bluetooth settings on your mobile device and select “NOVA” from the list of available devices.

The ARCSOUND NOVA features a built-in microphone for hands-free calls. The button functions in Bluetooth mode are as follows:

You can experience high-resolution, lossless audio by connecting your ARCSOUND NOVA speaker to your computer or other compatible devices using the USB-C cable.

1. Use the USB-C cable to connect your device and the NOVA speaker.

2. Press and hold the power button to turn NOVA on. (To disconnect Bluetooth, press and hold the play/pause button).

3. Open the settings on your device, select the speaker, and enable it for audio output.

*Note: High-resolution lossless audio over USB-C connection requires compatible lossless audio content from supported apps/services.

To pair two ARCSOUND NOVA speakers for an enhanced audio experience:

1. Power on both speakers.

2. Press the TWS buttons simultaneously on both speakers to enter True Wireless Stereo (TWS) mode.

Note:

A) When TWS pairing is successful, the main speaker will flash a blue light, and the secondary speaker will show an orange light. If TWS is disconnected, both speakers will flash blue and emit a voice prompt saying “Bluetooth”.

B) To disconnect from TWS mode, short press the TWS button on either speaker, and a voice prompt will notify you of the disconnection.

C) The next time both speakers are used, the TWS pairing will automatically reconnect.

When the speaker’s battery is low, it will issue a voice prompt, and the volume will automatically decrease. Charge the speaker with the included USB-C power cable.