AQUADISTRI REPTO SMART (01) PDF Document

The AQUADISTRI REPTO SMART thermostat consists of the following parts:

1. Power plug

2. Time display

3. Temperature display

4. Power socket

5. Time period indicator

6. Working indicator

7. Temperature probe

To set the temperature unit on your AQUADISTRI REPTO SMART thermostat, follow these steps:

1. Press and hold the main button.

2. While holding the main button down, rotate it 180° counter-clockwise.

3. Release the main button. The display will now only show either °C or °F.

4. Rotate the main button clockwise or counter-clockwise to switch between °C and °F.

5. Press and hold the main button for 3 seconds to complete the setting.

To set the clock on your AQUADISTRI REPTO SMART thermostat, please follow this procedure:

1. Press and hold the main button.

2. While holding the main button down, rotate it 180° clockwise.

3. Release the main button. The time will be displayed, and the hour will be flashing.

4. Rotate the main button clockwise or counter-clockwise to set the correct hour.

5. Press the main button to switch to the minute setting. The minutes will start flashing.

6. Rotate the main button clockwise or counter-clockwise to set the correct minutes.

7. Press and hold the main button for 3 seconds to complete the setting.

To program the time periods and their corresponding temperatures on your AQUADISTRI REPTO SMART thermostat, use the following steps:

1. Press and hold the main button for 3 seconds to enter the setting stage. The “T1” time period indicator will start flashing.

2. Rotate the main button clockwise or counter-clockwise to select the time period you wish to set, from T1 up to T8.

3. Press the main button to enter the Time setting stage for the selected period. The time display will start flashing.

4. Rotate the main button to increase or decrease the start time for this period in 30-minute increments (from 00:00 to 23:30).

5. Press the main button to enter the Temperature setting stage. The temperature display will start flashing.

6. Rotate the main button to increase or decrease the desired temperature for this period (from 20°C to 50°C). You can also rotate to the “OFF” position to switch the heating device off during this period.

7. Press and hold the main button for 3 seconds to complete the setting.

While in the time setting stage (Step 4 of setting time periods), rotate the main button counter-clockwise past 00:00 to delete the setting for that time period. The remaining time periods will be rearranged in order.

During the setting process, if you do not make any input for 15 seconds, the current setting value will be saved automatically, and the thermostat will return to the normal working state.

The technical data for the AQUADISTRI REPTO SMART thermostat is as follows:

Temperature control range: 20°C ~ 50°C / 68°F ~ 122°F

Temperature measuring range: 0°C ~ 60°C / 32°F ~ 140°F

Input voltage: AC 110 ~ 240V 50 Hz / 60Hz