ANKO ZB2025011304 (01) PDF DOCUMENT

The main parts of the ANKO ZB2025011304 camera are:

Exterior:

Spindle

Shutter button

Gear

Rear cover

Cover switch

Interior:

Spindle

Sprocket

Gear

Rewind button

Film compartment

Chamber cylinder

To load film into your ANKO ZB2025011304 camera, follow these steps:

STEP 1: Toggle the rear cover switch downward to open the rear cover.

STEP 2: Push the small spindle upward in the left film compartment.

STEP 3: Place the film cartridge upside down (with the film bulge facing downward) into the film compartment, ensuring it is fully seated.

STEP 4: Press the spindle downward to secure it.

STEP 5: Insert the hole at the end of the film leader into the sprocket at the bottom-right corner of the film chamber.

STEP 6: Hold the film in place with one finger while using your other finger to turn the gear on the upper-left side. Rotate the gear until the film wraps around the chamber’s cylinder for more than one full rotation (ensure the film does not snap back).

STEP 7: Press the film leader firmly against the central sprocket, then continue rotating the top-right gear to ensure the film lies flat and taut. And close the rear cover securely.

To take a photo with your ANKO ZB2025011304, follow these instructions:

STEP 8: Continue rotating the top-right gear until it stops. This advances the film to the next frame.

STEP 9: Press the shutter button to take a photo. After each shot, you must repeat Step 8 before taking the next photo.

To unload the film from your ANKO ZB2025011304 camera after finishing the roll, follow these steps:

STEP 10: Press the rewind button located at the bottom-right corner of the camera.

STEP 11: Lift the main spindle from the top-left compartment and rotate it in the direction indicated by the arrow to rewind the film back into the cartridge.

STEP 12: Once the film is fully rewound, open the rear cover, pull out the spindle, and remove the film cartridge. The film is now ready for development.

Yes, please be aware of the following warnings for the ANKO ZB2025011304 camera:

The camera is not suitable for use with film below ISO400, especially when shooting inside or in bad weather outside.

Do not open the rear cover while shooting, as this will expose the film and the developed photos will turn white.