ANKO JLR-80722 (01) PDF Document

The package contains:

• 1 x Water Ripple Light

• 1 x 30cm USB-C Cable (Type A to Type C)

• 1 x Remote Control (2 x 1.5 V AAA batteries are not included)

• 1 x Instruction Manual

1. Please fully charge the water ripple light before the first use.

2. Long press the switch sign button for about 3 seconds or use the remote control to turn the light on/off.

3. After turning it on, short press the switch sign button or use the remote control to change the colors you want.

Connect the USB-C cable to the DC5V/1A charger for charging. The indicator light displays red when charging and turns green when fully charged.

1. Battery installation by an adult is required.

2. Remove the battery compartment covers of the remote control, and insert 2 x 1.5 V AAA batteries (Not included).

3. Please notice the battery placement of the anode and cathode of the remote control.

4. Caution! Danger of explosion if the batteries are incorrectly replaced.

① Reduce brightness

② Turn off the light

③ Turn on the light

④ Flash effect

⑤ Strobe effect

⑥ Fade effect

⑦ Smooth effect

⑧ Sixteen corresponding color Light

⑨ Increase brightness

1. Flash: Quickly switches between different colors in a flashing effect. The color changes instantly without any gradual transition.

2. Strobe: Activates and deactivates the motor.

3. Fade: Smoothly transitions from one color to another without abrupt changes, ensuring a seamless effect.

4. Smooth: Produces a soft warm white light. You can add other colors besides yellow and white by pressing the button.

Note: When the Smooth mode is activated, the Flash, Strobe, and Fade effects will be temporarily disabled. To enable these effects again, please exit the Smooth mode by pressing the white or yellow light button, or press the Smooth button again.

Please read this instruction manual before using this product and follow all the safety instructions to avoid damage caused by improper use.

• Keep product and accessories away from rain or moisture, as this may result in fire or electric shock.

• Do not place this product and accessories in areas that are too high or too low in temperature, otherwise it may cause the product failure, fire or explosion.

• Do not disassemble or modify this product (including replacement of the built-in battery) and accessories without authorization.

• Do not allow children or pets to swallow the battery to avoid injury or explosion of the battery.

• Ensure the battery is installed correctly. Failing to do so could result in fire or explosion. Replace only with the same or equivalent type.

• The battery cannot be subjected to high or low extreme temperatures, low air pressure at high altitude during use, storage or transportation.

• Replacement of a battery with an incorrect type can result in an explosion or the leakage of flammable liquid or gas.

• Do not use harsh chemicals, cleaning agents, or strong detergents to clean the product or accessories. Please use a clean, dry soft cloth to wipe the product or its accessories.

• Using unapproved or incompatible power supplies, chargers, or power supplies may cause fire, explosion, or other hazards.

• If the product malfunction due to electrostatic discharge or a brief power surge, turn off or disconnect power then turn on or reconnect it.

• The light source of this product is not replaceable, when the light source reaches its end of life, the whole luminaire shall be replaced.

• Use 5VDC 1A 5W SELV power source to charging the product.

• Use provided USB cable to charge the product only.

• For indoor use only.

• This appliance contains rechargeable batteries that are non-replaceable.

– Batteries are to be inserted with correct polarity.

– Do not mix different types of batteries or new and used batteries.

– Non-rechargeable batteries are not to be recharged.

– Rechargeable batteries are only to be charged under adult supervision.

– Rechargeable batteries are to be removed from the product before being charged.

– The supply terminals are not to be short-circuited.

– Remove batteries from the product when not in use for extended time or when batteries become exhausted.

– Dispose of batteries responsibly.

– Do not dispose of in fire.