AMAZON BASICS B07D3F336H (01) PDF Document

When using the AMAZON BASICS B07D3F336H, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

Do not attempt to repair the product yourself. In case of malfunction, repairs are to be conducted by qualified personnel only.

To avoid overheating, do not cover the product.

Do not use this product in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

During cleaning or operation, do not immerse the electrical parts of the product in water or other liquids. Never hold the product under running water.

Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

Children of less than 3 years should be kept away unless continuously supervised.

Children aged from 3 years and less than 8 years shall only switch on/off the product provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the product or perform user maintenance.

The product must not be located immediately below a socket outlet.

Do not use this product with a programmer, timer, separate remote control system or any other device that switches the product on automatically, since a fire risk exists if the product is covered or positioned incorrectly.

Do not use this product in the immediate surroundings of a bath, a shower or a swimming pool.

Do not use if there are visible signs of damage to the product.

Use this product on a horizontal and stable surface.

Before connecting the product to the power supply, check that the power supply voltage and current rating corresponds with the power supply details shown on the product rating label.

Never use a damaged product! Disconnect the product from the electrical outlet and contact your retailer if it is damaged.

Do not operate the product with wet hands or while standing on a wet floor. Do not touch the power plug with wet hands.

Disconnect the product from the power supply when it is not in use.

Do not use this product in areas where dangerous and flammable materials, like petrol, paint thinner, paints and lacquers are used.

This product is classified as protection class II. This means the AMAZON BASICS B07D3F336H is equipped with reinforced or double insulation between the mains supply circuit and the output voltage or the casing. Therefore it does not require a safety connection to an electrical earth (ground).

The AMAZON BASICS B07D3F336H is intended for the following uses:

This product is only suitable for well insulated spaces or occasional use.

This product is intended for temporary heating or ventilating residential rooms.

This product is intended for household use only. It is not intended for commercial use.

This product is intended to be used in dry indoor areas only.

No liability will be accepted for damages resulting from improper use or non-compliance with the instructions.

Keep any packaging materials away from children as these materials are a potential source of danger, such as suffocation.

Check for transport damages.

Clean the product before first use.

Before connecting the product to the power supply, check that the power supply voltage and current rating corresponds with the power supply details shown on the product rating label.

The power indicator stays on as long as the power plug is connected to the power source.

1. Connect the power plug to an appropriate power outlet.

2. Turn the thermostat knob clockwise all the way to high position (+).

3. Set the mode knob to the desired setting:

Solid Circle Symbol: The product is off.

Fan Symbol: Fan only mode.

Single Wave Symbol: Low heat mode.

Double Wave Symbol: High heat mode.

1. Switch on the product.

2. When the desired temperature is reached, turn the thermostat knob counter-clockwise until it turns off.

3. The thermostat control maintains the temperature by turning the product on and off automatically.

The product is designed to automatically shut-off when tipped over. When returned to the proper upright position, the product will resume normal operation.

To prevent electric shock, unplug before cleaning. During cleaning, do not immerse the electrical parts of the product in water or other liquids. Never hold the product under running water.

To clean, wipe with a soft, slightly moist cloth.

Dry the product after cleaning.

Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.

Store in a cool and dry place away from children and pets, ideally in original packaging.

Avoid any vibrations and shocks.

The type of heat output/room temperature control used is with mechanic thermostat room temperature control (YES).

The following controls are NOT featured (NO):

Manual heat charge control, with integrated thermostat.

Manual heat charge control with room and/or outdoor temperature feedback.

Electronic heat charge control with room and/or outdoor temperature feedback.

Fan assisted heat output.

Single stage heat output and no room temperature control.

Two or more manual stages, no room temperature control.

With electronic room temperature control.

Electronic room temperature control plus day timer.

Electronic room temperature control plus week timer.

Room temperature control, with presence detection.

Room temperature control, with open window detection.

With distance control option.

With adaptive start control.

With working time limitation.

With black bulb sensor.