ALLIANCE AWN43RSN305NW29 (01) PDF Document

To enter the factory test procedure for the ALLIANCE AWN43RSN305NW29, follow these steps:

1. Disconnect electrical power from the unit.

2. Reconnect electrical power to the unit.

3. Wait about 10 seconds.

4. Turn the Cycle Selection knob to the position opposite of Normal Eco and stay on that selection for at least one second.

5. Press and hold the Start/Pause button.

6. Change the Cycle Selection knob to Normal Eco within 5 seconds; otherwise, the Start press will be invalid.

7. Stay on Normal Eco for at least one second to enter the Factory Test Mode.

8. To advance through the sequence of test steps, press the Start/Pause button.

To verify the cycle switch on the ALLIANCE AWN43RSN305NW29, use the Cycle Switch Test. Turn the Cycle Selection knob through all selections. A combination of LEDs will light to show which inputs are active for each selection. Press the Start/Pause button to advance to the next step.

Test the mixing valve solenoids using an Ohm meter based on the following resistance ranges. Note that readings slightly out of range may be due to meter conditions and do not necessarily indicate failure.

You can rapid advance the ALLIANCE AWN43RSN305NW29 to the final spin/drain step by following these steps:

1. Make sure EXTRA RINSE is in the OFF position.

2. Press and hold the START/PAUSE button. After about three seconds the current cycle status light will turn off.

3. Continue holding the START/PAUSE button for another 7 to 8 seconds until the SPIN light comes on then release the button.

4. If the lid was unlocked, the LID LOCK light will come on and the lid will lock. Once locked, the machine will start to drain and spin.

5. After the final spin/drain step, the control will reset to normal operation.

If after changing the upper control board, the ALLIANCE AWN43RSN305NW29 is sending an error code (WASH and RINSE LEDs flash once) during the first fill, the pressure sensor harness may have been installed incorrectly. Follow these steps to correct the error:

1. Disconnect electrical power from the unit.

2. Remove the screws holding the hood assembly to the rear hood panel.

3. Tip the control panel down to locate the H7 connection block (a 4-pin block with white, red, and gray wires).

4. Press the connection block release arm and remove the block.

5. Relocate the connection block so the release arm is at the three o’clock position to match the lock tab on the control.

6. Re-install the control hood.

7. Reconnect electrical power to the unit.

8. Run the ALLIANCE AWN43RSN305NW29 through a cycle to verify proper operation.

Follow these procedures to level the ALLIANCE AWN43RSN305NW29:

1. Place a level on the cabinet top and check if the washer is level from side to side and front to back.

2. If the washer is not level, tilt the washer back to access the front leveling legs. Loosen the locknuts and adjust the legs by screwing them into or out of the washer base.

3. Once adjusted, tilt the washer forward on the front legs and lower it back down into position to set the rear self-leveling legs.

4. The washer must not rock. When the washer is level and does not rock, tighten the locknuts securely against the bottom of the washer base. If these locknuts are not tight, the washer will not remain stationary during operation.

When replacing or reinstalling the drive bell on the ALLIANCE AWN43RSN305NW29, torque the bolts to the specifications in the following table: