AEG L7WE7631BI (01) PDF Document

The technical data for the AEG L7WE7631BI is as follows:

1. Ensure that the electrical power is available and the water tap is open.

2. Pour 2 litres of water into the detergent compartment marked for the washing phase. This action activates the drain system.

3. Pour a small quantity of detergent into the compartment marked for the washing phase.

4. Set and start a programme for cotton at the highest temperature without any laundry in the drum. This removes all possible dirt from the drum and the tub.

The detergent dispenser of the AEG L7WE7631BI has specific compartments for different additives:

Compartment with one vertical line: Used for the prewash phase, soak programme, or stain remover.

Compartment with two vertical lines: Used for the main washing phase.

Compartment with a flower icon: Used for fabric softener and other liquid treatments such as fabric conditioner or starch.

Flap for powder or liquid detergent: This flap can be adjusted depending on whether you are using powder or liquid detergent. Position it UP for powder and DOWN for liquid.

1. Press the On/Off button for a few seconds to activate the appliance.

2. Open the door and load the laundry one item at a time without exceeding the maximum load.

3. Close the door firmly and add detergent and additives to the appropriate compartments.

4. Turn the programme dial to select the desired washing programme.

5. To change the temperature or spin speed, touch the related buttons. You can also set additional options by touching their respective buttons.

6. Touch the Start/Pause button to start the programme. The door will lock and the display will show the indicator for the door locked.

After touching the Start/Pause button, the AEG L7WE7631BI begins the ProSense load detection:

1. The appliance detects the load within the first 30 seconds. During this phase, the Time Save bars play an animation and the drum rotates shortly.

2. The programme duration is adjusted accordingly and could increase or decrease. After a further 30 seconds, water filling starts.

3. In case of a drum overload, the MAX indicator flashes on the display. You can pause the appliance for 30 seconds to remove the exceeding garments and then touch Start/Pause again to restart the detection.

1. Press the On/Off button to activate the appliance and load the laundry.

2. Put the detergent and additives in the appropriate compartments.

3. Turn the programme dial to the desired washing programme.

4. Tap the Mode button once to activate the drying function. Both Wash and Dry indicators will appear on the display.

5. Tap the Auto Dry button repeatedly to select the required dryness level (Iron dry, Cupboard dry, or Extra dry). Alternatively, use the Time Dry button to set a specific drying duration.

6. Touch the Start/Pause button to start the cycle. The ProSense estimation will begin, and the display will show the remaining time for the complete cycle.

1. Press the On/Off button for some seconds to activate the appliance.

2. Load the laundry one item at a time.

3. Turn the programme dial to the programme suitable for the items to be dried.

4. Tap the Mode button twice to set the appliance to drying only. The Dry indicator illuminates and the Wash indicator goes off.

5. Select the dryness level using the Auto Dry button or set a specific time using the Time Dry button.

6. Touch the Start/Pause button to start the drying programme.

To remove fluff inside the drum of the AEG L7WE7631BI, you should set a special cleaning programme:

1. Empty the drum.

2. Clean the drum, the gasket, and the door with a wet cloth.

3. Set the Machine Clean programme and the Mode Dry together to activate the anti-fluff action.

4. Touch the Start/Pause button to start the programme.

To extend the life of your AEG L7WE7631BI, follow this indicative cleaning schedule:

Descaling: Twice a year.

Maintenance wash: Once a month.

Clean door seal: Every two months.

Clean drum: Every two months.

Remove fluff inside the drum: Twice a month.

Clean detergent dispenser: Every two months.

Clean drain pump filter: Twice a year.

Clean the inlet hose and the valve filter: Twice a year.

1. Disconnect the mains plug and open the pump cover.

2. Place a suitable bowl below the drain pump access to collect flowing water.

3. Turn the filter 180 degrees anti-clockwise to open it without removing it, allowing the water to flow out. Repeat this until the water stops.

4. Turn the filter fully anti-clockwise to remove it.

5. Remove fluff and objects from the filter recess and ensure the impeller of the pump can rotate.

6. Clean the filter under a water tap.

7. Put the filter back into the guides, turning it clockwise until it is tight, and close the pump cover.

If the AEG L7WE7631BI encounters a problem, it may show the following alarm codes:

E10: The appliance does not fill with water properly. Check if the water tap is open and the inlet hose is not kinked.

E20: The appliance does not drain the water. Check if the sink spigot or drain hose is clogged.

E40: The appliance door is open or not closed correctly. Ensure the door is properly shut.

E91: Internal fail. No communication between electronic elements. Switch the appliance off and on again.

EH0: The mains supply is unstable. Wait until the supply is stable.

EF0: The anti-flood device is on. Disconnect the appliance and close the water tap.

In case of power failure or failure where the door remains locked, follow these steps to open the AEG L7WE7631BI door:

1. Press the On/Off button to switch the appliance off and disconnect the mains plug.

2. Ensure the water temperature is not too high and the laundry is not hot. Wait for them to cool down if necessary.

3. Ensure the water level inside the drum is not too high. Perform an emergency drain if needed.

4. Pull the emergency unlock trigger (located near the drain filter) downward once. Pull it again, keep it tensed, and simultaneously open the appliance door.

The AEG L7WE7631BI offers the following automatic dryness levels:

Iron dry: Laundry is suitable to be ironed. (Load: up to 4 kg for Cottons and Linen).

Cupboard dry: Laundry is ready to be put in store. (Load: up to 4 kg for Cottons, 3 kg for Synthetics, 2 kg for Delicates, 1 kg for Wool, 2 kg for Outdoor, 3 kg for Denim).

Extra dry: Laundry is to be fully dried, ideal for towelling materials. (Load: up to 4 kg for Cottons and Linen, 3 kg for Denim).

To prevent children from playing with the control panel on the AEG L7WE7631BI, you can use the Child Lock option:

To activate or deactivate this option, hold the Time Save button pressed until the Child Lock indicator comes on or goes off on the display.

When activated, the appliance will default to this option even after switching it off or changing a programme. If you press any button while the lock is active, the indicator blinks to show the buttons are disabled.

Consumption values for the Eco 40-60 programme (Washing only) on the AEG L7WE7631BI:

Consumption values for the Eco 40-60 programme and Cupboard dry level (Wash and dry cycle):