YAMAHA TRUE X BAR 90A SR-X90A (01) PDF Document

The model number, serial number, and power requirements for your YAMAHA TRUE X BAR 90A SR-X90A can be found on or near the nameplate, which is located at the bottom of the unit.

If you find that your YAMAHA TRUE X BAR 90A SR-X90A is the source of interference, which can be confirmed by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following measures:

• Relocate either the YAMAHA TRUE X BAR 90A SR-X90A or the device that is being affected by the interference.

• Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

• In the case of radio or TV interference, relocate or reorient the antenna. If the antenna lead-in is a 300-ohm ribbon lead, change the lead-in to a co-axial type cable.

To comply with FCC and ISED radiation exposure limits, the YAMAHA TRUE X BAR 90A SR-X90A should be installed and operated with the radiator (the unit itself) kept at least 20 cm or more away from a person’s body. Additionally, the transmitter for the YAMAHA TRUE X BAR 90A SR-X90A must not be co-located or operated in conjunction with any other antenna or transmitter.

If you notice any of the following abnormalities with your YAMAHA TRUE X BAR 90A SR-X90A, immediately turn off the power and disconnect the power plug. Continued use could cause electric shocks, a fire, or malfunctions.

• The power cord/plug is damaged.

• An unusual smell, unusual sound, or smoke is emitted from the unit.

• Foreign material or water gets into the interior of the unit.

• There is a loss of sound during use.

• There is a crack or damage in the unit.

After disconnecting the power, immediately request an inspection or repair from the dealer where you purchased the YAMAHA TRUE X BAR 90A SR-X90A or from qualified Yamaha service personnel.

To ensure safe operation of your YAMAHA TRUE X BAR 90A SR-X90A, follow these power supply precautions:

• Use only the supplied power cord. Do not use this power cord for other units.

• Do not do anything that could damage the power cord, such as placing it near a heater, bending it excessively, altering it, scratching it, or placing it under a heavy object.

• Use the YAMAHA TRUE X BAR 90A SR-X90A with the power supply voltage printed on it.

• Do not touch the power plug or cord if there is a chance of lightning.

• Check the electric plug periodically and remove any dirt or dust that may have accumulated on it.

• Ensure the AC outlet you are using is easily accessible. If a problem occurs, immediately turn off the power switch and disconnect the plug.

• Do not use an AC outlet where the power plug fits loosely when inserted.

• When disconnecting the power plug, always hold the plug itself and not the cord.

• Insert the power plug firmly all the way into the AC outlet.

• If not using the YAMAHA TRUE X BAR 90A SR-X90A for long periods, pull the power plug from the AC outlet. A minute current is still flowing even when the power switch is off.

When installing your YAMAHA TRUE X BAR 90A SR-X90A, follow these guidelines to ensure safety and proper function:

• Install in the manner instructed in the manual. Confirm that the finished installation is safe and secure, and carry out periodic safety inspections.

• Do not place the YAMAHA TRUE X BAR 90A SR-X90A in an unstable position where it might accidentally drop or fall over.

• Do not obstruct heat dissipation. Do not cover it with any cloth, install it on a carpet or rug, or use it in a confined, poorly-ventilated location.

• Ensure adequate space around the sound bar: at least 10 cm (4 in) on top, 10 cm (4 in) on the sides, and 10 cm (4 in) on the rear (or 10 cm (4 in) on the bottom when mounting on a wall).

• Ensure adequate space around the subwoofer: at least 10 cm (4 in) on top, 10 cm (4 in) on the sides, and 10 cm (4 in) on the rear.

• Do not install the YAMAHA TRUE X BAR 90A SR-X90A in places with corrosive gases, salt air, or excessive smoke or steam.

• Avoid installing the unit in a location exposed to direct sunlight, extreme heat or cold, or excessive dust or vibration.

• For wall mounting, ensure it is done by the dealer or qualified service personnel as it requires special skills and experience.

• If using a wireless function, avoid installing the YAMAHA TRUE X BAR 90A SR-X90A near metal walls or desks, microwave ovens, or other wireless network devices.

Please observe the following safety warnings when using your YAMAHA TRUE X BAR 90A SR-X90A:

• **Disassembly:** Do not disassemble or modify the unit.

• **Water Warning:** Do not expose the unit to rain, use it near water, or place containers with liquids on it. Never insert or remove an electric plug with wet hands.

• **Fire Warning:** Do not place any burning items or open flames near the unit.

• **Handling:** Be careful not to drop or apply strong impact to the unit.

• **Wireless Unit:** Do not use the YAMAHA TRUE X BAR 90A SR-X90A near medical devices or facilities. Do not use it within 15 cm (6 in) of persons with a heart pacemaker or defibrillator implant.

For safe handling of the remote control batteries for your YAMAHA TRUE X BAR 90A SR-X90A, follow these instructions:

• Do not disassemble a battery.

• Do not dispose of a battery in a fire.

• Do not expose the battery to extreme low air pressure, heat (like direct sunlight), cold, or excessive dust or humidity.

• Do not attempt to recharge non-rechargeable batteries.

• If batteries leak, avoid contact with the leaked fluid. If contact occurs with eyes, mouth, or skin, wash immediately with water and consult a doctor.

• Use only the specified batteries. Do not mix battery types (e.g., alkaline with manganese), new and old batteries, or batteries from different makers.

• Do not carry or store batteries together with metal objects.

• Keep batteries away from children.

• Always insert batteries in conformity with the +/- polarity markings.

• When batteries run out, or if the YAMAHA TRUE X BAR 90A SR-X90A is not to be used for a long time, remove the batteries from the remote control.

• When storing or discarding batteries, insulate the terminal area with tape or other protection.

To protect your hearing when using the YAMAHA TRUE X BAR 90A SR-X90A, do not use the unit for a long period of time at a high or uncomfortable volume level, as this can cause permanent hearing loss. If you experience any hearing loss or ringing in the ears, consult a physician. Before connecting the YAMAHA TRUE X BAR 90A SR-X90A to other devices, turn off the power for all devices to prevent hearing loss, electric shock, or device damage.

Please observe the following handling precautions for your YAMAHA TRUE X BAR 90A SR-X90A:

• Do not insert foreign materials like metal or paper into the bass reflex port of the subwoofer.

• Keep small parts out of the reach of infants.

• Do not stand on or sit on the equipment, place heavy items on top of it, place it in a stack, apply unreasonable force to buttons and terminals, or hang on/lean against the sound bar if it is wall-mounted.

• Avoid pulling connected cables to prevent the unit from falling.

• Do not place vinyl, plastic, or rubber products on the unit.

• If condensation forms due to drastic temperature changes, leave the YAMAHA TRUE X BAR 90A SR-X90A for several hours without turning it on until it is completely dry.

• Do not touch the speaker units to avoid damage.

• Before moving the YAMAHA TRUE X BAR 90A SR-X90A, turn off the power switch and disconnect all cables. Always use two or more people when transporting or moving the unit.

To maintain your YAMAHA TRUE X BAR 90A SR-X90A, first remove the power plug from the AC outlet before cleaning. Use a dry, soft cloth for cleaning. Using chemicals such as benzine or thinner, cleaning agents, or chemical scrubbing cloths can cause discoloration or deformation.

When making connections with your YAMAHA TRUE X BAR 90A SR-X90A, follow these important guidelines:

• Do not connect this product directly to a public Wi-Fi and/or Internet Service. Only connect the YAMAHA TRUE X BAR 90A SR-X90A to the Internet through a router with strong password protections.

• If connecting external units, be sure to thoroughly read the manual for each unit and connect them in accordance with the instructions.

• Do not connect the YAMAHA TRUE X BAR 90A SR-X90A to industrial units. This unit is designed for consumer-use only.

Before you transfer ownership or dispose of your YAMAHA TRUE X BAR 90A SR-X90A, you should initialize the product settings to their defaults. This is important because if you transfer or dispose of the product without initializing the settings, your personal data may be stolen by a third party. If you plan to transfer ownership, also include the product documentation and supplied accessories. Follow the rules of your local authority for disposing of the YAMAHA TRUE X BAR 90A SR-X90A and its accessories, and be sure to discard used batteries in accordance with local regulations.

It is normal for air to be blown out from the bass reflex port of the subwoofer on your YAMAHA TRUE X BAR 90A SR-X90A. This is not a malfunction and occurs particularly often when outputting music with heavy bass.