WHIRLPOOL WDT780SAE (01) PDF MANUAL

WHIRLPOOL WDT780SAE (01) PDF SUMMARY:

What are the Electrical Requirements?

120-volt, 60 Hz, AC-only, 15- or 20-amp fused electrical supply. Copper wire only. A time delay fuse or circuit breaker and separate circuit is recommended.

What are the instructions for Direct Wiring Dishwasher?

Use flexible, armored or nonmetallic, sheathed copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances. Use a UL Listed or CSA Approved conduit connector.

What are the instructions for Connecting Dishwasher with a Power Supply Cord?

Use power supply cord kit (Part Number 4317824) marked for use with dishwashers. Follow the kit instructions for installing the power supply cord. Power supply cord must plug into a grounded 3 prong outlet located in the cabinet next to the dishwasher opening. Outlet must meet all local codes and ordinances.

What are the Water Supply Requirements?

A hot water line with 20 to 120 psi (138 to 862 kPa) water pressure. Water temperature must be 120°F (49°C) water at dishwasher.

What are the instructions for Water Supply?

Use " O.D. copper tubing with compression fitting or flexible braided water supply line. Note: " minimum plastic tubing is not recommended. Use a 90° elbow with " hose connection with rubber washer (Part Number W10273460). Do not solder within 6" (15.2 cm) from water inlet valve.

What are the Drain Requirements?

A new drain hose is supplied with your dishwasher. If this is not long enough, use a new drain hose with a maximum length of 12’ (3.7 m) (Part Number 3385556) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher. Make sure to connect the drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20" (50.8 cm) minimum above the floor. It is recommended that the drain hose either be looped up and securely fastened to the underside of the counter, or be connected to an air gap. Make sure to use an air gap if the drain hose is connected to house plumbing lower than 20" (50.8 cm) above subfloor or floor. Use 1/2 " (1.3 cm) minimum I.D. drain line fittings. If required, the air gap should be installed in accordance with the air gap installation instructions. When connecting the air gap, a rubber hose (not provided) will be needed to connect to the waste tee or disposer inlet.

What is measurement A?

Insulation may be compressed (not used on all models).

What is measurement B?

For panel-ready models, dishwasher depth is 24" (60 cm) not including the " (1.9 cm) custom door panel.

What is measurement C?

Door handles may protrude forward of the face of the dishwasher; varies by model.

What is the height of cabinet opening for 4" (10 cm) toekick?

341/2" (86.3 cm)

What is the minimum height measured from the lowest point on the underside of the countertop?

33 " (85.1 cm) by removing the rear leveling legs from dishwasher.

What is the minimum measurement from narrowest point of opening?

Check that all surfaces have no protrusions that would prohibit dishwasher installation.

What does the shaded areas of cabinet walls indicate?

Where utility connections may be installed.

What is measurement D?

Clear Area

What is measurement E?

24 " (61 cm) 24 "(61 cm)