Free English VOLKSWAGEN JETTA 2005 (08) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD VOLKSWAGEN JETTA 2005 (08) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How can I find the engine code and engine number on my VOLKSWAGEN JETTA 2005?
The engine code and engine number can be found on a sticker located on the control housing. They are also available on the vehicle data plate and stamped on the crankcase above the gearbox.
What are the engine specifications for my VOLKSWAGEN JETTA 2005?
| Specification | Details |
|---|---|
| Engine Code | BLF |
| Displacement | 1598 cm3 |
| Output | 85 kW at 6000 rpm |
| Torque | 155 Nm at 4000 rpm |
| Bore | 76.5 mm |
| Stroke | 86.9 mm |
| Compression ratio | 12.0 |
| Valves per cylinder | 4 |
| Minimum RON | 95 Unleaded |
What are the safety precautions when working on the fuel supply system of my VOLKSWAGEN JETTA 2005?
When working on the fuel supply system, observe the following:
1. All wirings (e.g., fuel, hydraulic system, activated charcoal filter system, coolant and refrigerant liquid, brake liquid, vacuum) must be installed in the original way.
2. Ensure sufficient clearance to all moving or hot components.
3. The fuel line is under pressure. Before loosening lines, wrap a cloth around the connection, then release pressure by carefully removing the line.
4. Prevent skin contact with fuel by wearing fuel resistant gloves.
5. Place an extraction hose close to the sender opening in the fuel tank to extract fuel fumes.
What are the cleanliness rules for working on the fuel injection system of my VOLKSWAGEN JETTA 2005?
Follow these five rules when working on the system:
1. Thoroughly clean all joints and surrounding areas before dismantling.
2. Place removed parts on a clean surface and cover. Use lint free cloths only.
3. Carefully cover opened components or seal them if repairs cannot be carried out immediately.
4. Only unpack replacement parts immediately prior to installation.
5. Do not work with compressed air if the system is open, and do not move the vehicle unless absolutely necessary.
How do I check the engine oil level on my VOLKSWAGEN JETTA 2005?
The oil level is checked using the dipstick. The level must be between the minimum and maximum marks. If the level is in the area between the minimum mark and the start of the hatched field, you may replenish with a maximum of 0.5 liters of engine oil. Do not fill above the maximum mark.
How do I check the cooling system for leaks on my VOLKSWAGEN JETTA 2005?
Use a cooling system tester and the appropriate adapter on the coolant reservoir. Generate a pressure of approximately 1 bar using the hand pump. If the pressure drops, search for the leak and eliminate the fault. Additionally, the pressure relief valve in the sealing cap must open at a pressure between 1.4 and 1.6 bar.
What are the compression pressure specifications for my VOLKSWAGEN JETTA 2005?
The compression pressure specifications are as follows:
New: 10 to 15 bar
Wear limit: 7 bar
Permissible difference between all cylinders: 3 bar
How do I check the compression pressure on my VOLKSWAGEN JETTA 2005?
1. Ensure engine oil temperature is at least 30 degrees Celsius.
2. Remove the engine cover and ignition coils.
3. Unscrew all spark plugs.
4. Connect a compression tester to the spark plug thread.
5. Have a second person depress the accelerator pedal fully and operate the starter until the tester shows no further pressure increase.
What is the torque setting for the spark plugs on my VOLKSWAGEN JETTA 2005?
The spark plugs should be tightened to 30 Nm.
How do I drain and fill the coolant on my VOLKSWAGEN JETTA 2005?
To drain, open the expansion tank cap and pull the coolant hose off the lower radiator connection or expansion tank. To fill, ensure the correct coolant mixture (G 12 additive in accordance with TL VW 774 F). For a 40 percent mixture, use 2.25 liters of G 12 and 3.35 liters of water for -25 degrees Celsius protection. For a 50 percent mixture, use 2.8 liters of both for -35 degrees Celsius protection.
CLICK HERE TO DOWNLOAD VOLKSWAGEN JETTA 2005 (08) PDF DOCUMENT