VEVOR ZT1011 (01) PDF MANUAL

To correct harmful interference, you can:

Reorient or relocate the receiving antenna.

Increase the distance between the product and receiver.

Connect the product to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for assistance.

The performance data and specifications for the 15 HEX model are as follows:

Connect the tubes by series. Each purple circle requires its own power source.

Please be careful when connecting the light bars with the connectors. Do not damage the copper needle in the connectors.

Make your desired pattern and test it before installing it on the ceiling.

Only 1 connector for AC input cord: Black-Line, White-Neutral, Green-Ground.

There should be 2 wires out to connect 100-240AC 50/60Hz. Please install by a professional electrician.

Installation and servicing are to be performed only by qualified personnel. If not qualified, consult an electrician.

When the LED tube is inserted into connectors, make sure that the hook on the connectors is stuck into the hole of the LED tube.

When disassembling the LED tube, the hook on the connectors needs to be lifted with a single batch, so that the LED tube can be easily removed.

Step 1: Determine the position of installing the lamp according to the overall size of the whole lamp, and then assemble the lamps into the shape of the desired picture, and then fix it on the ceiling with screws.

Step 2: Connect to the power cable. The wiring is Black for Line, White for Neutral, and Green for Ground.

Step 1: You can use cable ties instead of screws to fix the lights if there is a grid-type ceiling in your room.

Step 2: Connect to the power cable. The wiring is Black for Line, White for Neutral, and Green for Ground.