TUNDRA INDUSTRIAL TUNJKTRL10LR (01) PDF MANUAL

TUNDRA INDUSTRIAL TUNJKTRL10LR (01) PDF SUMMARY:

What are the operating instructions for the trolley jack?

Assembly: Insert the handle to the handle socket and put the guide pin on the handle to the corresponding hole on frame. The handle should be perpendicular to the frame, then tighten the handle socket by bolt M10 x 35 on handle cap.

Raising: Twist the knob handle clockwise, tighten the return valve by universal joint, then rotate the guide pin handle 90°upward to the socket to lock it. Lift the lifting arm by pushing the foot pedal or the handle. In order to avoid damage to universal joint, please do not hold the knob when pushing the handle.

Lowering: Slowly turn the release valve knob counter-clockwise.

---

Where should I keep the jack?

Keep the jack in a clean, dry place and away from aggressive gas or any harmful substances. Keep the hydraulic system free of any dust or dirt.

---

What type of lubrication is recommended for the trolley jack?

A periodic coating of light lubricating oil to pivot points, axles, and hinges will help to prevent rust and assure that wheels, castors, and pump assemblies move freely.

---

How should I check and maintain the pump piston and ram?

Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily cloth. Lower the saddle to its lowest position when not in use.

---

How do I add oil to the trolley jack?

Lower the saddle fully, unscrew the oil-fill bolt slowly to avoid gas spurt out to smear the operator. Fill clean noncongealable oil until it reaches the level of the inner cylinder.#15 machine oil could be a substitute when noncongealable oil isn’t available. (Do not use it below-5°C if it with #15 machine oil).

---

What is the first thing I should do before using the jack?

Read and completely understand all operating instructions and warning labels before you use this jack.

---

Where should I keep the operator’s manual?

Keep the operator’s manual in a safe place for routine maintenance.

---

What is the jack designed for?

This jack is designed only for lifting, not for long-time supporting purposes. Always support the vehicle with appropriately rated jack stands before working under it.

---

What should I do to avoid any dangerous situations?

Do not overload this jack beyond its rated capacity to avoid any dangerous.

---

What type of surface should the jack be used on?

Use only on hard, level surfaces capable of jack-rated capacity loads.

---

Where should I refer to find approved lifting points on the vehicle?

Refer to the vehicle manufacturer’s owner’s manual to locate approved lifting points on the vehicle. Center jack saddle under the lift point to avoid unbalanced loading.

---

What could happen if I fail to read the warnings?

Failure to read these warnings may result in loss of load damage to the jack and/or personal injury and/or property damage.

---

What is this automotive tool used for?

This is an ideal automotive tool which is used for lifting vehicles such as cars, tractors, etc.

---

What are the advantages of this jack?

This jack has a lot of advantages such as reasonable structure, attractive appearance, easy to operate, with advanced hydraulic circuit, good function, long service lift, etc.

---

What temperature range can this jack operate in?

It can work well between -20°c -45°c if it used with fine noncongealable oil.

---

What is the security device designed for?

This jack is designed with a security device that will stop when the lifting arm reaches the MAX height.

---

Table: Specification for the 5T and 10T Trolley Jacks

Model:	Lifting Capacity (Ton)	Min Height (mm)	Max Height (mm)	Jack Length (mm)	Net Weight (kg)
5t	5	160	600	1400	83
10t	10	160	600	1510	108