TOZO PA1 (01) PDF MANUAL

Press and hold the Power button (indicated by the power symbol) for 1 second to turn the speaker on. Press and hold the Power button for 1 second again to turn the speaker off.

1. **First time use:** When you turn the speaker on for the first time, it will automatically enter pairing mode, and the blue light will flash quickly. 2. **If previously paired:** When powered on, the speaker will try to reconnect to the last device (blue light flashes slowly). To enter pairing mode manually, short press the Bluetooth (BT) key twice. The blue light will then flash quickly. 3. **If already connected:** To disconnect the current device and enter pairing mode, short press the BT key twice.

• **Fast Flashing Blue Light:** The speaker is in Bluetooth pairing mode (light on 250ms, off 250ms).
• **Slow Flashing Blue Light:** The speaker is attempting to reconnect to a previously paired device (light on 500ms, off 500ms).
• **Solid Blue Light:** The speaker is successfully connected to a Bluetooth device.

The speaker will remain in Bluetooth pairing mode for 5 minutes. If no device is connected within this time, the speaker will automatically shut down.

While a Bluetooth device is connected, short press the Bluetooth (BT) key twice. This will disconnect the current device and put the speaker back into pairing mode (blue light flashes fast).

• **Volume Up:** Short press the “+” button to increase the volume by 1 step. There are 16 total volume steps.
• **Volume Down:** Short press the “-” button to decrease the volume by 1 step. There are 16 total volume steps.

• **Next Song:** Press and hold the “+” button for 1.5 seconds.
• **Previous Song:** Press and hold the “-” button for 1.5 seconds.

In music mode, short press the Play/Pause button (indicated by the triangle symbol) to switch between playing and pausing the music.

When you receive a phone call, short press the Play/Pause button (indicated by the phone receiver symbol next to the triangle) to answer the call. During a call, short press the Play/Pause button to hang up.

When you receive an incoming call, press and hold the Play/Pause button for more than 1 second to reject the call.

When the speaker is connected to your phone, press and hold the Play/Pause button for 1 second to wake up the voice assistant (e.g., Siri). Please ensure you have enabled the wake-up permission on your phone beforehand.

Short press the EQ button to switch between the 3 available sound effect modes: Treble+, Standard, and Bass+.

Press and hold both the “+” and “-” buttons together for 10 seconds. This will restore the speaker to its original factory settings.

1. Turn on the first speaker (Speaker 1) and connect it to your phone via Bluetooth as usual. 2. Press and hold the Bluetooth (BT) key on Speaker 1 for 5 seconds. It will enter the group pairing state. 3. Turn on the second speaker (Speaker 2). Ensure it is in its default pairing state (or press its BT key twice if needed). 4. Speaker 2 should automatically find and connect to Speaker 1.

When two speakers are connected in Party Pairing mode, press and hold the Bluetooth (BT) key on *either* speaker for 5 seconds to exit the group mode.

Connect a USB Type-C cable to the charging port on the speaker and the other end to a suitable power source.

• **When Speaker is Off:** A solid red light indicates the speaker is charging. The red light turns off when charging is complete.
• **When Speaker is On:** A red light will turn on for 1 second every 3 seconds to indicate the speaker is charging.

There is an indicator light that shows the approximate battery level:

• **Blinking Red Light:** Battery level is low (less than 20%).
• **Blinking Blue Light:** Battery level is sufficient (more than 20%).

*(Note: This is separate from the Bluetooth status light)*

Yes, the speaker has an IPX7 waterproof rating. This means it is suitable for use during sports, can handle sweat, and can even be washed with water and soap. It can withstand submersion in water up to 1 meter deep for up to 30 minutes. Ensure the charging port cover is securely closed before exposure to water.

The TOZO App can enhance your speaker’s functionality. You can download it from:

• The official TOZO website (www.tozostore.com)
• Google Play Store (for Android devices)
• Apple App Store (for iOS devices)

The speaker includes a lanyard loop, allowing you to attach the included lanyard or your own strap for easy carrying, such as attaching it to a backpack.

For the latest products, parts, accessories, and further assistance, please visit the official TOZO website: http://www.tozostore.com. You can also contact customer support via email at: info@tozostore.com.