THETFORD SHB353 (01) PDF MANUAL

Use the appliance exclusively for cooking and not for other purposes, for example, heating a room. This could cause carbon monoxide poisoning and overheating of the appliance. The manufacturer is not responsible for damage resulting from improper use or incorrect setting of the controls.

The use of this gas cooking appliance produces heat, humidity, and combustion products in the room where it is installed. Ensure that there is sufficient ventilation in the room when the appliance is in operation. In case of prolonged use, provide additional ventilation by opening a window or increasing the suction power of the extractor hood.

This appliance can be used by children from 8 years of age and by people with reduced physical, sensory or mental capabilities and/or with a lack of experience and knowledge, only if they are supervised or have been instructed on the safe use of the equipment and understand the associated risks.

Yes, the burners and pan supports are hot during and after use. Allow all components to cool down before touching them to avoid serious injury.

Never extinguish a cooking fire with water. Turn off the appliance and cover the flames with a lid or a fire blanket.

Keep children under 8 years of age away from the appliance or under constant supervision.

Do not allow children to play with the appliance.

Do not allow children to clean or perform maintenance on the appliance without supervision.

Use only components supplied by the manufacturer.

Do not make any modification or adjustment to the appliance unless authorized by the manufacturer or its representative.

No. There is a fire hazard if you store items on the cooking surface.

Do not close the glass lid when the burners are on or still hot.

Before using the appliance for the first time, follow these steps:

Ensure that all packaging materials have been removed.

Clean the appliance with hot water and household detergent and dry carefully with a soft cloth.

Ensure that the gas supply is properly connected.

Ensure the appliance is connected to the 12V DC battery for the electric ignition.

Ensure that the pan supports are correctly positioned.

Light the gas burners and let them run to expel any odors and vapors.

Use only LPG (liquefied petroleum gas). The appliance runs on propane or butane. Propane is preferable to butane, as the latter has poor performance at ambient temperatures below 10°C and cannot be used at an ambient temperature below 5°C.

This appliance is suitable for use with LPG and must not be used with any other gas.

To light the burners:

1. Push and turn the control knob.

2. Turn it anti-clockwise to the maximum open position.

3. For models with electric ignition: Press the ignition button. For models without ignition: Hold a lit match or a gas lighter near the burner.

4. Keep the control knob pressed for about 10-15 seconds, then release it.

5. Adjust the flame height.

To turn off the burner, turn the control knob to the 0 position.

If the burner goes out accidentally, turn the control knob to the 0 position and wait at least 1 minute before relighting the burner.

If the burner does not light within 15 seconds, return the control knob to the 0 position and release it. Wait at least 1 minute then repeat the steps to light the appliance.

Lift the glass lid.

Open the water tap.

Close the water tap.

Be careful not to get the burners wet with water from the tap or sink. Wet burners can work erratically and go out.

Hard or soft water can leave a brown or white film in the sink. To avoid this, dry the sink with a soft cloth. Clean the sink thoroughly at least once a week with a cloth and household detergent.

Avoid letting containers used for cooking overlap the edges of the appliance. Use correctly sized pans and position them in the center above the burners.

Ensure there is at least 10 mm of space between the pans and the edges of the hob.

Position the pans so that the handles do not protrude from the front of the appliance.

Make sure that the flame from the gas burners heats the bottom of the pan and not the sides.

Do not leave the appliance unattended during use.

Do not use the appliance with the vehicle in motion.

At the end of cooking, return the control knob to the 0 position.

Keep the appliance clean and avoid the accumulation of grease and food residues.

For model SCU353, the recommended pan diameters are:

Auxiliary burner: Ø 100 – 140mm

Semi-rapid burner: Ø 120 – 200mm

Rapid burner: Ø 150 – 280mm

For model SHB353, the recommended pan diameters are:

Auxiliary burner: Ø 100 – 140mm

Semi-rapid burner: Ø 120 – 200mm

Rapid burner: Ø 150 – 280mm

Thetford recommends an annual inspection by an authorized service center. Between annual maintenance intervals, clean the appliance regularly after use.

Always remove any spills or contamination immediately after use with hot water and soap. Dry the surface with a soft cloth.

Use a universal non-abrasive cream cleaner and an abrasive sponge to clean stubborn dirt or grease.

To clean the burner rings, make sure the holes are not clogged.

The control knobs can be removed for cleaning. The knobs are easy to reposition.

Do not use abrasive detergents, abrasive metal sponges or hard brushes. They could damage the appliance.

Do not allow wet cloths, detergent pads, food residues or other cleaning products or dirt to dry on the surface. They can cause corrosion, marks or even rust.

Do not leave cleaning products containing bleach in contact with the stainless steel.

Be aware that the mineral content in water (such as iron or lime) can affect the appearance of the metal.

Use a dedicated stainless steel cleaner or polish to remove superficial scratches.

Always clean in the direction of the satin finish and not across the grain.

As soon as you smell gas:

1. Check that all burners are off.

2. Extinguish all naked flames and do not smoke.

3. Immediately cut off the gas supply at the cylinder.

4. Do not use electrical switches.

5. Open all doors and windows.

LPG is heavier than air. Gas leaks accumulate at lower levels. Following the strong and unpleasant smell of gas, it is possible to determine the location of the leak. To pinpoint its exact location, use a special leak detection spray. Never use a naked flame to locate the leak!

All maintenance work must be carried out by an authorized and competent person. Before starting any maintenance work, the appliance must be allowed to cool down and must be disconnected from both the gas and electrical supply. After each maintenance intervention, the appliance must be tested to ensure gas tightness and electrical safety.

For assistance, contact your local authorized service center providing the model and serial number details from the data plate, as well as the date of purchase.

Close the gas valve on the cylinder.

Disconnect the battery.

Make sure the control knobs are in the 0 position.

Close the glass lid.

Clean and dry the appliance with a cloth.

Burner Characteristics for Models SHB353 & SCU353

This appliance must be connected to earth (grounded).