TCL FLIP GO TCL-4058L (01) PDF Document

The external components of the TCL FLIP GO TCL-4058L are:

Top (closed):

• Camera

• External display

Left Side:

• Headset Connector

• Charging Port

Right Side:

• Volume Key

Bottom (closed):

• Microphone

Your phone already has a NANO SIM card installed. MicroSD™ cards (up to 32GB) may be purchased separately.

NOTE: Power off the device before opening the back cover to install a microSD or replace the NANO SIM card.

Step 1. With the device facing down, remove the back cover from the bottom left corner. Use your fingernail to carefully lift the cover away from the device body.

Step 2. Remove the battery using your fingernail to lift from the top left corner.

Step 3. To insert a SIM card or microSD card, push the card into the card slot with the gold-colored contacts facing down.

Step 4. To remove the SIM card or microSD card, press down on the small plastic tab, then slide out the card. Do not use force or any sharp objects.

Step 5. Re-install the battery by aligning the gold contact points of the battery with the gold contact points of the device. It only fits one way. Press down to snap in place.

Step 6. Carefully align the back cover with tabs and press into place. It only fits one direction.

Step 7. Charge your phone fully before turning it on and starting the setup process. Insert the small end of the charging cable into the charger port on the phone. Insert the other end of the cable into your wall charger and plug it into a wall outlet.

WARNING: Only use the charger and cable supplied with the phone. Using incompatible chargers or tampering with the charging port could damage your phone and void the warranty.

To turn on your phone:

Press and hold the End/Power Key. The first time you turn on your phone, you may need to activate it by following the on-screen instructions.

To turn off your phone:

Press and hold the End/Power Key for about 2 seconds. Then press the Navigation Key to select “Power Off”, and press the Center Soft Key (OK) to confirm.

To keep your phone contents secure, you can lock the phone screen by creating a password.

1. From the Home screen, press the Center Soft Key (OK), select Settings > Phone settings > Security > Screen lock.

2. Press the Navigation key to select On and then press the Center Soft Key (OK) to enable screen lock.

3. Enter the passcode and press the Center Soft Key (OK) to go to the next step.

4. Enter the passcode again and press the Center Soft Key (OK) to create it.

1. Dial the desired number then press the Call Key to place the call.

2. If you make a mistake, press the Back/Delete Key to delete the incorrect digits.

3. Press the Right Soft Key to display more Options. Then press up or down on the Navigation key to select which option you would like to complete.

When you receive a call:

• Press the Left Soft Key or the Call Key to answer.

• If the device is closed, you will get a preview of an incoming call on the external screen. You can accept the call by flipping the device open to begin talking immediately.

• Press the Right Soft Key or the End/Power Key to reject the call.

• To mute the ringtone volume of an incoming call, press the Volume Up/Down Key.

Press and hold the 1 key to call and listen to your voicemail.

Go to Settings > Software update > Check for updates to check for software updates.

To perform a factory data reset, go to Settings > Phone settings > Reset > Factory data reset.

Go to Settings > Phone settings > Accounts > Press the Right Soft Key to Options > Add.

• You are advised to switch off the phone from time to time to optimize its performance.

• Switch the phone off before boarding an aircraft.

• Switch the phone off when you are in health care facilities, except in designated areas.

• Switch the phone off when you are near gas or flammable liquids. Strictly obey all signs and instructions posted in a fuel depot, petrol station, or chemical plant, or in any potentially explosive atmosphere.

• When the phone is switched on, it should be kept at least 15 cm from any medical device such as a pacemaker, a hearing aid or insulin pump, etc. In particular when using the phone, you should hold it against the ear on the opposite side to the device, if any.

• To avoid hearing impairment, pick up the call before holding your phone to your ear. Also move the handset away from your ear while using the “hands-free” mode because the amplified volume might cause hearing damage.

• Do not let children use the phone and/or play with the telephone and accessories without supervision.

• If your phone has a removable cover, note that your phone may contain substances that could create an allergic reaction.

• Always handle your phone with care and keep it in a clean and dust-free place.

• Do not allow your phone to be exposed to adverse weather or environmental conditions, such as moisture, humidity, rain, infiltration of liquids, dust, sea air, etc. The manufacturer’s recommended operating temperature range is 0°C (32°F) to 40°C (104°F).

• Do not dismantle or attempt to repair your mobile phone yourself.

• Do not drop, throw or bend your mobile phone.

• Do not use the phone if the screen is damaged, cracked or broken to avoid any injury.

• Do not paint it.

• Use only batteries, battery chargers, and accessories which are recommended by TCL Communication Ltd. and its affiliates and are compatible with your phone model.

• Remember to make back-up copies or keep a written record of all important information stored in your phone.

Observe the following precautions for battery use:

• Do not attempt to open the battery (due to the risk of toxic fumes and burns).

• Do not puncture, disassemble or cause a short-circuit in the battery.

• Do not burn or dispose of a used battery in household garbage or store it at temperatures above 60°C.

Batteries must be disposed of in accordance with locally applicable environmental regulations. Only use the battery for the purpose for which it was designed. Never use damaged batteries or those not recommended by the manufacturer.

Travel charger: QC13

• Input: 100-240V, 50/60Hz, 500mA

• Output: 5V, 3A / 9V, 2A / 12V, 1.5A

Battery: Softpack

• 5010mAh typ, 4900mAh min

To find more information about labeling, such as the FCC ID, follow this path: Touch Settings > About phone > E-Label or press *#07#.

Your phone is identified by an IMEI (phone serial number) shown on the packaging label and in the phone’s memory. It is recommended that you note the number the first time you use your phone by entering *#06# and keep it in a safe place. It may be requested by the police or your carrier if your phone is stolen. This number allows your phone to be blocked, preventing a third person from using it, even with a different SIM card.