SONY BRAVIA KDL-60NX720 (01) PDF Document

Step 1. Remove the protection sheet from the remote control.

Step 2. Push and slide the battery cover upward.

Step 3. Insert the two size AAA batteries.

Point your remote control directly at the IR sensor located on your SONY BRAVIA KDL-60NX720. Make sure that no objects are blocking the path between the remote control and the IR sensor. Fluorescent lamps can interfere with your remote control; try turning them off if you experience issues. If problems persist, reinsert or replace your batteries and ensure they are inserted correctly.

Disconnect all cables when carrying the SONY BRAVIA KDL-60NX720. Carry the TV with an adequate number of people based on its size. Ensure correct hand placement for safety and to avoid damage. Do not expose the screen to direct illumination or sunlight for best picture quality, and avoid rooms with reflective wall or floor materials. Do not move the TV from a cold area to a warm area, as sudden temperature changes can cause moisture condensation that may lead to poor picture or color. Ensure there are no objects in front of the TV and do not expose the Intelligent Presence Sensor to direct sunlight or other strong light to avoid malfunction.

Step 1. Align the TV with the two dowels of the Table-Top Stand and gently place the SONY BRAVIA KDL-60NX720 down, ensuring the triangle mark is facing the front.

Step 2. Attach the TV and Table-Top Stand using the supplied screw and the hexagon wrench.

Step 3. Tighten to approximately 3 N.m (30 kgf.cm).

Step 1. Complete all cable connections before proceeding and connect the TV to a power outlet.

Step 2. Check that the ENERGY SAVING switch is set to on.

Step 3. Press the power button on the SONY BRAVIA KDL-60NX720. The power indicator will light green.

Step 4. Follow the on-screen instructions. The ENERGY SAVING switch must be on to set the clock and obtain program information for the Rovi On Screen Guide.

Step 5. Select Continue to scan for available channels. If you do not wish to use the built-in tuner, select Skip.

Secure the SONY BRAVIA KDL-60NX720 to a wall or stand. Do not allow children to climb on furniture or the TV. Do not install the TV on slippery, unstable, or uneven surfaces, or on furniture that can be used as steps. Route all cables so they are not accessible to children. To secure the stand, use two angle braces to attach the stand to a wall stud. To secure the TV to the stand, use a machine screw (M4 for this model) and a rope or chain strong enough to support the weight of the TV, ensuring there is no excess slack.

Unplug the TV and other connected equipment before cleaning. Wipe the LCD screen gently with a soft cloth. Remove stubborn stains using a cloth slightly moistened with a mild soap and warm water solution. Never spray water or detergent directly on the SONY BRAVIA KDL-60NX720, as it may drip inside and cause damage. Never use strong solvents like thinners, alcohol, or benzine. Do not plug the TV back in until all moisture has evaporated.

Count how many times the indicator flashes with a three-second interval between flashes. Press the power button on the SONY BRAVIA KDL-60NX720 to turn it off, disconnect the AC power cord, and report the number of flashes to technical support.

Check if the Sleep Timer, Timer, or Idle TV Standby are activated. Also, verify if the Auto Shut-off setting is set to On, which will turn off the TV after 15 minutes if no signal is received. Additionally, check if the Presence Sensor in the Eco settings is activated, which turns off the picture if no viewer is detected for a preset time.

The following table details the supported formats: