SKYLINK SL310T (01) PDF Document

Both the SKYLINK SL310T transmitter and receiver are built-in with a dip switch to enable users to choose their own codes. The factory pre-sets the odd numbers of the dip switch to the “ON” position and even numbers to the “OFF” position. It is recommended that a different code be set for both the transmitter and receiver after installation.

Receiver Code Setting:

Remove the front lower cover of the receiver case. Set the code of the dip switch, then replace the cover after setting the code.

Transmitter Code Setting:

Remove the battery cover. Set the code of the dip switch of the transmitter to match the code of the SKYLINK receiver. Then replace the battery cover after testing the transmitter with the receiver.

Your SKYLINK SL310T receiver is a universal radio digital receiver.

1. Operating Voltage: The operating voltage is from 18V to 30V AC or DC, supplied by the garage or gate operator.

2. Code Setting: Remove the front lower cover of the receiver case. Set the code of the dip switch, then replace the cover after setting the code.

3. Wiring Connection:

– White wire: connect to common

– Red wire: connect to 24V

– Black Wire: relay output, connect to relay

4. Antenna Wire: Please DO NOT remove the yellow wire. Ensure that it is in an up-right position to receive data signals from the transmitter.

The SKYLINK SL310T transmitter is operated by a 12V Alkaline battery (#23A). To install it, remove the battery cover, place the battery in the compartment, and then replace the battery cover.