SENNHEISER SPECTERA DAD UHF (01) PDF MANUAL

The box contains:

– SPECTERA DAD (UHF) or SPECTERA DAD (1G4)

– Quick Guide

– Safety Guide

– Compliance Sheet

The overview highlights the following components:

– Status LED

– Hole for rigging safety cable

– Ruggedized RJ45 connector port

– Connection point for a Microphone stand (using optional 3/8″ or 5/8″ accessories)

The SPECTERA DAD receives power and data through a single connection to a SPECTERA Base Station (not included).

1. Connect one end of a Cat 5e or higher network cable (max. 100 m, not included) to the Ruggedized RJ45 port on the SPECTERA DAD.

2. Connect the other end of the network cable to an appropriate port on the SPECTERA Base Station.

Ensure the Base Station is correctly powered using its PSU 1 or PSU 2 inputs.

1. Optionally, mount the SPECTERA DAD onto a microphone stand using the 3/8″ or 5/8″ thread (requires optional accessories).

2. Connect the Ruggedized RJ45 network cable (Cat 5e or higher, max 100m, not included) to the corresponding port on the SPECTERA DAD.

3. Connect the other end of the cable to the Base Station (not included).

LED Appearance	Status
Green (Flashing slowly)	Connecting
Green (Solid)	Connected and RF transmitting
Yellow (Solid)	Connected and RF muted
Green (Flashing rapidly)	Identify function active
Red / Green (Alternating flash)	Firmware update in progress

The minimum recommended distance between the SPECTERA SEK transmitter (UHF or 1G4, not included) and the SPECTERA DAD antenna is greater than 5 meters (> 5 m). Placing the transmitter closer than this distance is not recommended for optimal performance.

– When using multiple SPECTERA DAD antennas, maintain a minimum distance of 20 meters (≥ 20 m) between them.

– Ensure the SPECTERA DAD antenna is placed at least 0.5 meters (≥ 0.5 m) away from walls or other large obstructions.

The E-label information for the SPECTERA DAD (UHF) and SPECTERA DAD (1G4) can be shown on the display of the SPECTERA Base Station (not included).

The following optional accessories are mentioned:

– Microphone stand adapters (3/8″ or 5/8″) for mounting.

– Antenna cable Cat 5e*:

– 10 m (Art. no. 700068)

– 25 m (Art. no. 700069)

– 50 m (Art. no. 700070)

*Note: Standard Cat 5e or higher cables up to 100m can also be used but are not included. The base station and transmitters are also not included.

The full Instruction Manual can be downloaded from the Sennheiser website at http://www.sennheiser.com/download.