SCARLETT VITASPA SC-CA300S01 (01) PDF Document

Free English SCARLETT VITASPA SC-CA300S01 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.

CLICK HERE TO DOWNLOAD SCARLETT VITASPA SC-CA300S01 (01) PDF DOCUMENT

If this is not the document you want for this product, click here to see if we have any other documents for this product.

How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.

What should I do after unpacking the SCARLETT VITASPA SC-CA300S01?

Unpack the appliance.

Wipe all parts with wet cloth.

Place the device on dry, level and stable surface.

How do I prepare the water for use with the SCARLETT VITASPA SC-CA300S01?

Pour warm water into the evaporator tank, using measuring cup.

Attention! Do not allow water to get inside the housing. If water gets inside the housing, switch the power off immediately, pour the water out of the evaporator tank and dry the unit thoroughly. In case of trouble, contact service center.

How do I attach the facial attachment to the SCARLETT VITASPA SC-CA300S01 for facial steaming?

Attach the facial attachment to the base unit.

Place the grille for herbs over the evaporator tank. You can use the empty grille or place herbs between two halves of the grille for flavor and therapeutic effect.

How can I adjust the vapor intensity on the SCARLETT VITASPA SC-CA300S01?

Adjust the vapor intensity with the adjustment knob.

L – low vapor intensity;

H – high vapor intensity.

When the required intensity is selected, the LED will light.

What are the preparation steps before starting a facial steaming session with the SCARLETT VITASPA SC-CA300S01?

The appliance is now ready for use.

Rinse off the make-up and wash your face thoroughly.

What precautions should I take while using the facial steaming function of the SCARLETT VITASPA SC-CA300S01?

When steaming the skin, keep your eyes closed.

Do not put your face closer than 10 cm to the attachment.

The recommended time of exposure 10 to 20 minutes.

What should I do immediately after completing a facial steaming session with the SCARLETT VITASPA SC-CA300S01?

Once completed, turn off the power by moving the adjustment knob to the “0” position.

Disconnect the appliance from mains. Wait about 10 to 15 minutes until the appliance has cooled.

Detach the facial attachment from the base unit.

Drain the remaining water from the evaporator tank.

Attention! It is strictly forbidden to switch the power on without water inside the tank, or to keep the power on until water evaporates completely.