Free English SAN JOSE TECHNOLOGY MA-67 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SAN JOSE TECHNOLOGY MA-67 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How do I install the SAN JOSE TECHNOLOGY MA-67 antenna?
Step 1. Secure your SAN JOSE TECHNOLOGY MA-67 antenna to the top of your vehicle and carry its cable into the vehicle.
Step 2. Link the cable connector to your GPS receiver.
Step 3. Start with your navigation.
What are the physical specifications of the SAN JOSE TECHNOLOGY MA-67 antenna?
| Construction: | Polycarbonate-radome at top, die-cast shell at bottom/rubber gasket for water seal in between |
| Dimension: | 58mm (L) x 48mm (W) x 15mm (H) |
| Weight: | 65 grams (excluding cable & connector) |
| Color of Radome: | Standard in dark gray, other colors available upon request |
| Standard Mounting: | Magnet mount with two magnets |
| Optional Mounting 1: | Screw mount with two M3 tapped holes on the plastic flange of MA-67 |
| Optional Mounting 2: | Customized metal sheet |
What are the antenna element specifications for the SAN JOSE TECHNOLOGY MA-67?
| Center Frequency: | 1575.42 MHz +/- 1.023 MHz |
| Polarization: | R.H.C.P. (Right Hand Circular Polarization) |
| Absolute Gain at Zenith: | +5 dBi typically |
| Gain at 10° Elevation: | -1 dBi typically |
| Axial Ratio: | 3 dB max. |
| Output VSWR: | 1.8 Max. |
| Output Impedance: | 50 ohm |
What are the specifications of the Low Noise Amplifier (LNA) in the SAN JOSE TECHNOLOGY MA-67?
| Center Frequency: | 1575.42 MHz +/- 1.023 MHz |
| Gain: | 30 dB typically |
| Band Width: | 2 MHz min. |
| Noise Figure: | 2.0 max. |
| Out of Band Attenuation: | 30dB min. @F0 +/- 50MHz |
| Supply Voltage: | 4.5~5.5V DC |
| Current Consumption: | 28 mA +/- 3 mA |
| VSWR: | 2.0 max. |
| Output Impedance: | 50 ohm |
What are the cable and connector specifications for the SAN JOSE TECHNOLOGY MA-67?
| RF Cable: | 5 meter RG174/U (standard), other length available |
| Pulling Strength: | 6 Kg./5 sec. with molded plastics on connector end for strain relief |
| Connector Available: | BNC, TNC, FME, GT5, MCX (OSX), SMA, SMB or SMC in straight or right angle type |
| Optional Adapters: | FME~MCX, FME~BNC, FME~SMA, FME~SMB, FME~TNC |
What is the overall performance of the SAN JOSE TECHNOLOGY MA-67, including the antenna element, LNA, and cable?
| Center Frequency: | 1575.42 MHz |
| Gain: | 27 dB typically |
| Noise Figure: | 2.0 max. |
| Band Width: | 2 MHz |
| Axial Ratio: | 3 dB max. |
| VSWR: | 2.0 max |
| Output Impedance: | 50 ohm |
What are the environmental specifications for the SAN JOSE TECHNOLOGY MA-67 antenna?
| Operating Temperature: | -30°C~+85°C |
| Storage Temperature: | -40°C~+90°C |
| Relative Humidity: | 95% non-condensing |
| Waterproof: | 100% waterproof |
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD SAN JOSE TECHNOLOGY MA-67 (01) PDF DOCUMENT