RYOBI OP40261 (01) PDF Document

To ensure safe operation of the RYOBI OP40261 battery pack, please follow these safety rules:

READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions may result in electric shock, fire and/or serious personal injury.

Battery tools are always in operating condition. Be aware of possible hazards when not using your battery tool or when changing accessories.

Do not place battery tools or their batteries near fire or heat to reduce the risk of explosion and injury.

Do not crush, drop or damage the battery pack. Do not use a battery pack or charger that has been dropped or received a sharp blow. A damaged battery is subject to explosion. Properly dispose of a dropped or damaged battery immediately.

Batteries can explode in the presence of an ignition source, such as a pilot light. Never use any cordless product in the presence of an open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.

Always wear eye protection with side shields marked to comply with ANSI Z87.1.

Do not use a battery pack that is damaged or modified, as it may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.

Do not modify or attempt to repair a damaged battery pack.

Do not expose the battery pack to fire or excessive temperature. Exposure to fire or temperature above 265°F (130°C) may cause an explosion.

Have servicing performed by a qualified repair person using only identical replacement parts.

Do not charge the RYOBI OP40261 battery tool in a damp or wet location.

Do not use, store, or charge battery packs in locations where the temperature is less than 50°F or more than 100°F. Do not store outside or in vehicles.

Do not charge the battery in an area of extreme heat or cold. It will work best at normal room temperature.

Charge only with RYOBI 40 V lithium-ion battery chargers. Use of other chargers may result in personal injury, fire, or damage.

Under extreme usage or temperature conditions, battery leakage may occur. If liquid from the RYOBI OP40261 comes in contact with your skin, wash immediately with soap and water. If liquid gets into your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the risk of serious personal injury.

When the RYOBI OP40261 battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns, or a fire and can lead to personal injury or property damage.

Always remove the RYOBI OP40261 battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing the battery pack will prevent accidental starting that could cause serious personal injury.

Always remove the battery pack before storing the device.

When the battery becomes fully charged, unplug the charger from the power supply and remove the battery pack from the charger.

Keep the RYOBI OP40261 battery pack dry, clean, and free from oil and grease. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products, or any solvents to clean the battery pack.

The RYOBI OP40261 battery pack is designed with features that protect the lithium-ion cells and maximize battery life. If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged.

The RYOBI OP40261 lithium-ion battery pack can be used in temperatures down to -4°F. Put the battery pack on a tool and use the tool in a light duty application. After about a minute, the pack will warm up and begin operating normally.

To display the amount of charge left in the RYOBI OP40261 battery, press the charge level indicator button. The LED lights indicate the charge status as follows:

The RYOBI OP40261 battery packs are shipped in a low charge condition to prevent possible problems. Therefore, you should charge prior to first use. If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for an electrical check.

Charge the battery pack only with the recommended charger.

Refer to the charger operator’s manual for charging instructions.

Charging a Hot Battery Pack: When using a tool continuously, the battery pack may become hot. A hot battery pack may be placed directly onto the charger port, but charging will not begin until the battery temperature cools to within an acceptable temperature range. When a hot battery pack is placed on the charger, the charger may indicate the pack is not ready to charge. Please refer to the charger operator’s manual. When the battery pack cools, the charger will automatically begin charging.

Charging a Cold Battery Pack: A cold battery pack may be placed directly onto the charger port, but charging will not begin until the battery temperature warms to within an acceptable temperature range. When a cold battery pack is placed on the charger, the charger may indicate the pack is not ready to charge. Please refer to the charger operator’s manual. When the battery pack warms to approximately room temperature, the charger will automatically begin charging.

To obtain the longest possible battery life for your RYOBI OP40261, we suggest the following:

Remove the battery pack from the charger once it is fully charged and ready for use.

For battery pack storage longer than 30 days:

Store the battery pack where the temperature is below 80°F and away from moisture.

Store battery packs in a 30%-50% charged condition.

Every six months of storage, charge the pack as normal.

To preserve natural resources, please recycle or dispose of batteries properly. This product contains lithium-ion batteries. Local, state, or federal laws may prohibit disposal of lithium-ion batteries in ordinary trash. Consult your local waste authority for information regarding available recycling and/or disposal options.

WARNING! Upon removal, cover the battery pack’s terminals with heavy-duty adhesive tape. Do not attempt to destroy or disassemble the battery pack or remove any of its components. Lithium-ion batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as a short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

Corrosive or conductive fluids, such as seawater, chlorine, certain industrial chemicals, and bleach or bleach-containing products, can cause a short circuit in the battery pack.

If your RYOBI OP40261 battery pack is exposed to a corrosive or conductive fluid, do not attempt to use or charge the battery pack and immediately perform the following steps:

1. Wear appropriate personal protective equipment, including eye protection and rubber gloves.

2. Place your exposed battery pack in a large bucket, such as a 5-gallon or similar bucket, and fill the bucket with regular tap water. Do not place more than two packs in the bucket.

3. Locate the bucket outdoors in an area inaccessible to children and pets and away from all buildings, garages/sheds, structures, vehicles, and combustible/flammable materials.

4. Leave the battery pack(s) in the bucket filled with tap water and call Customer Service for additional instructions on the proper disposal of the exposed battery pack(s).

Battery packs exposed to corrosive or conductive fluids and failure to follow these steps can result in smoke/fire, serious personal injury, and/or property damage.