RUSSELL HOBBS 27121-56 (01) PDF Document

Follow basic safety precautions, including:

This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children must not use or play with the appliance. Keep the appliance and cable out of reach of children.

To avoid injury, take care when handling the blades, emptying the jug, and cleaning.

Don’t add hot liquid (over 40°C) as it may be ejected due to sudden steaming.

Misuse of the appliance may cause injury.

Unplug the appliance before assembly, disassembly, or cleaning.

Don’t leave the appliance unattended while plugged in.

If the cable is damaged, it must be replaced by the manufacturer, its service agent, or someone similarly qualified to avoid a hazard.

Do not immerse in any liquid.

Switch off (O) before fitting the jug to the motor unit.

Don’t use accessories or attachments other than those we supply.

Don’t use the appliance for any purpose other than those described in these instructions.

Don’t operate the appliance if it’s damaged or malfunctions.

Don’t run the motor continuously for more than 2 minutes becasue it may overheat. After 2 minutes switch off for at least 2 minutes to allow the motor to cool.

HOUSEHOLD USE ONLY

Turn to “CARE AND MAINTENANCE” and clean the appliance, to remove manufacturing dust, etc.

In use, treat the jug and blade unit as a single unit.

Step 1. Sit the motor unit on a stable, level surface.

Step 2. Check that the speed control is set to O.

Step 3. Lower the jug onto the motor unit and twist it clockwise to lock it. Your blender will not operate unless the jug is correctly fitted and locked.

Step 4. Remove the lid.

Step 5. Put the ingredients into the jug. Don’t fill past the 1500 ml mark. If you do, the contents may force the lid off when you start the motor.

Step 6. Replace the lid. Don’t operate the appliance without fitting the lid.

Step 7. Fit the cap to the hole in the lid, and turn it clockwise to lock it.

Step 8. Put the plug into the power socket.

Step 9. Move the speed control to the 1 or 2 position to operate your blender.

Step 10. Move and hold the speed control in the ⑩ position to operate your blender in short, controlled bursts.

Step 11. Release the control to stop.

Step 12. To add ingredients while the blender is working, remove the cap, pour the new ingredients through the hole, then replace the cap.

When you have finished:

Switch the appliance off by moving the speed control to the O position and unplug it.

Step 1. Switch the appliance off (O) and unplug it.

Step 2. Wipe the outside of the motor unit with a clean damp cloth.

Step 3. Hand wash the removable parts.

You may wash these parts in the top rack of a dishwasher.

You may wash these parts in the dishwasher.

If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface finishes. The damage should be cosmetic only, and should not affect the operation of the appliance.

Step 1. Remove the lid.

Step 2. Sit the jug upside down.

Step 3. Unscrew the blade unit and lift it off.

Step 4. Handle only the plastic – don’t touch the metal parts.

Step 5. Lift the seal away from the blade unit.

Step 6. Wash the seal and blade unit in warm soapy water, rinse, and air dry.

Step 7. Replace the seal round the blade unit.

Step 8. Replace the blade unit and screw it firmly onto the bottom of the jug.

Move the speed control to the 1 or 2 position to operate your blender.

Move and hold the speed control in the ⑩ position to operate your blender in short, controlled bursts.

Release the control to stop.