REMINGTON F7 STYLE F7000AU (01) PDF Document

Free English REMINGTON F7 STYLE F7000AU (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.

CLICK HERE TO DOWNLOAD REMINGTON F7 STYLE F7000AU (01) PDF DOCUMENT

If this is not the document you want for this product, click here to see if we have any other documents for this product.

How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.

What are the main components and parts of the REMINGTON F7 STYLE F7000AU?

The REMINGTON F7 STYLE F7000AU includes the following components:

1. On/off switch

2. Foil screens

3. Cutter assembly

4. Charging indicator lights

5. Hairpocket

6. Power port

7. Pop-up trimmer

8. Head release buttons

9. Stubble head guard

Included items not shown on the main diagram:

USB charging cable

Storage pouch

Cleaning brush

What are the important safety safeguards for the REMINGTON F7 STYLE F7000AU?

When using the REMINGTON F7 STYLE F7000AU, observe these precautions:

Do not use this appliance with damaged or broken tracks, foils, or cutters, as injury may occur.

The product is for use on facial hair only and is not intended for shaving hair on your head.

Do not plug or unplug the appliance with wet hands.

Never operate the appliance if it has a damaged cord or plug, if it is not working correctly, or if it has been dropped into water.

Keep the cord away from heated surfaces.

Always store the cable and shaver in a moisture-free location.

Do not wrap the cord around the appliance.

The hand-held part must be detached from the supply cord before using it in the bath or shower or cleaning it in water.

Charge, use, and store the product at a temperature between 0 degrees Celsius and 32 degrees Celsius.

How do I charge the REMINGTON F7 STYLE F7000AU?

Before using your REMINGTON F7 STYLE F7000AU for the first time, it is recommended to fully charge it. Follow these steps:

1. Ensure the product is switched off.

2. Connect the product to the USB cable.

3. Connect the USB end of the cable to a powered USB port.

The charge time from empty is approximately 120 minutes. Run time from a full charge is up to 80 minutes. To preserve battery life, let the batteries run out every 6 months and then fully charge them.

What do the charging lights indicate during use of the REMINGTON F7 STYLE F7000AU?

The charging lights on the REMINGTON F7 STYLE F7000AU display the remaining charge as follows:

Charge Remaining	75 – 100%	15 – 75%	10 – 15%	0 – 10%
Top Light	On	Off	Off	Off
Middle Light	On	On	Off	Off
Bottom Light	On	On	On	Flashing

What do the charging lights indicate while the REMINGTON F7 STYLE F7000AU is charging?

The charging lights on the REMINGTON F7 STYLE F7000AU indicate progress during the charging cycle:

Charge Progress	0 – 15%	15 – 60%	60 – 99%	Fully Charged
Top Light	Off	Off	Flashing	Flashing
Middle Light	Off	Flashing	On	Flashing
Bottom Light	Flashing	On	On	Flashing

Note: When fully charged, all lights will flash for 5 minutes and then turn off.

How should I operate the REMINGTON F7 STYLE F7000AU for shaving?

It is recommended to use the REMINGTON F7 STYLE F7000AU daily for up to two weeks to allow your beard and skin to adjust to the shaving system. To shave:

1. Switch the shaver on by pressing the on/off switch.

2. Stretch the skin with your free hand so the hairs stand upright.

3. Hold the shaving head so that the foils touch your face.

4. Use short linear strokes.

5. Always hold the shaver at right angles to the skin so all foils touch the skin with equal pressure.

6. Do not press hard against the skin to avoid irritation and damage to the foil heads.

How do I use the trimmer on the REMINGTON F7 STYLE F7000AU?

To use the pop-up trimmer on the REMINGTON F7 STYLE F7000AU:

1. Slide up the trimmer release button to activate the trimmer.

2. Hold the trimmer at a right angle to your skin.

3. To retract the trimmer, push the top rear of the trimmer down until it locks under the trimmer release button.

How do I achieve a stubble look with the REMINGTON F7 STYLE F7000AU?

To achieve a 3-day stubble look, fit the stubble head guard to your REMINGTON F7 STYLE F7000AU shaver before use.

How should I clean the REMINGTON F7 STYLE F7000AU?

Cleaning the REMINGTON F7 STYLE F7000AU after each use ensures long-lasting performance. Rinsing with warm water is the most hygienic method:

1. Press the head release buttons and pull the head upwards.

2. Tap out excess hair shavings.

3. Rinse the foils under running water.

4. Do not clean the shaving foil with a brush.

What are the signs that the foils and cutters on my REMINGTON F7 STYLE F7000AU need replacing?

To maintain high-quality performance, foils and cutters should be replaced regularly. Signs they need replacement include:

Irritation: You may experience skin irritation as foils become worn.

Pulling: As cutters wear, you may feel the shaver pulling your hair rather than giving a close shave.

Wear through: You may visually notice that the cutters have worn through the foils.

How do I replace the foils and cutters on the REMINGTON F7 STYLE F7000AU?

To replace the foil or cutters on the REMINGTON F7 STYLE F7000AU:

1. Press the head release buttons and pull the head upwards to remove it.

2. Fit the new head assembly over the hair pocket.

3. Press down until the new head assembly clicks into place.

What is the battery disposal procedure for the REMINGTON F7 STYLE F7000AU?

The REMINGTON F7 STYLE F7000AU contains a nickel metal hydride battery. The battery is not intended for removal under normal use. It should only be removed by a professional at a recycling center at the end of the product’s life.

Caution: Do not put the battery in a fire or mutilate it when disposing of it, as it may burst and release toxic materials. Do not short circuit the battery as it may cause burns.