REMINGTON BHT6100 (01) PDF Document

The key features of the REMINGTON BHT6100 are:

1. On/off switch

2. Trimmer

3. 3 attachment combs

To install the batteries in your REMINGTON BHT6100, follow these steps:

• Make sure the product is turned off.

• Rotate the battery compartment cap then pull off.

• Insert 1 “AA” alkaline battery, so that the (+) and (-) marks on the battery face the same marks in the battery compartment.

• Replace the cap.

Note: Remove batteries if the unit is not in use for long periods.

The REMINGTON BHT6100 offers the following cutting lengths based on the setting:

To use the detail attachment on your REMINGTON BHT6100:

• Hold the groomer with the surface (back side) of the blade guides against the skin.

• Use motions similar to using a wet blade to provide the closest trim.

• Attach the comb to the detail trimmer making sure to keep the adjustable guard orientated to the large cutting teeth, while covering the small cutting teeth.

Note: The Trim Shave Technology attachment provides a dual purpose solution for stubble or close results without irritation.

Follow these steps to trim body hair with the REMINGTON BHT6100:

• Place the flat top of the trimmer comb against the skin.

• Slowly slide the trimmer through the hair, in the direction of hair growth.

• Use slow and well-controlled movements.

• If hair builds up in the guide comb during the trimming process, switch the unit off, pull off the guide comb.

• Brush trimmer / rinse comb.

For the best results with your REMINGTON BHT6100, comb your hair in the direction that it grows so that the hairs are at their maximum height and facing in the same direction. Since all hairs do not grow in the same direction, you may want to try different trimming positions (i.e. upwards, downwards or across) for better results.

To ensure a long lasting performance, it is recommended to clean your REMINGTON BHT6100 after each use. The easiest and most hygienic way is by rinsing the product head with warm water. Always keep the trimmer in the “off” position when not in use.

After each use:

• Rinse the accumulated hair from the cutters and shake off excess water. Alternatively, use a brush.

• Gently tap on a flat surface to remove hair particles, and brush the remaining hairs away.

• Place one or two drops of cutter oil or sewing machine oil on the blades. Turn the clipper on to distribute the oil evenly, and wipe off any excess oil.

• Wipe the main unit with a damp cloth and dry immediately.

Note: Ensure that the groomer is turned off.

Please follow these important safety instructions for your REMINGTON BHT6100:

• The appliance must only be used by or under the supervision of a responsible adult.

• Use and store the appliance out of reach of children.

• Do not use attachments other than those supplied.

• This product is battery operated only.

• This product uses alkaline batteries. At the end of their life, the batteries must be removed from the appliance and be recycled or disposed of properly in accordance with your state and local requirements.

• Do not put in fire or mutilate your batteries when disposing as they may burst and release toxic materials.

• Do not short circuit as it may cause burns.

• Store the appliance at a temperature between 15°C and 35°C.

• Don’t put the appliance in liquid, don’t use it near water in a bath-tub, basin or any other vessel, and don’t use it outdoors.

• Do not use the appliance if it is damaged or malfunctions.

To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, the REMINGTON BHT6100, which is marked with a crossed-out wheeled bin symbol, must not be disposed of with unsorted municipal waste. It should be recovered, reused, or recycled.