Free English PYLE VIEW PLMD7 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD PYLE VIEW PLMD7 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I perform the wiring connection for the PYLE VIEW PLMD7?
The wiring connections for the PYLE VIEW PLMD7 are as follows:
1. Connect the White and Red RCA Line Outputs to the DVD player.
2. Connect the Black wire to GROUND.
3. Connect the RED wire to +12v Power.
4. Connect the Car Antenna to the designated input.
Where should I avoid installing the PYLE VIEW PLMD7?
Do not install the unit in the following locations:
1. Locations exposed to direct sunlight.
2. Where hot air is discharged from the car heater.
3. In areas subject to extreme temperatures.
What are the mounting distance requirements for the PYLE VIEW PLMD7?
The PYLE VIEW PLMD7 FM Stereo Transmitter must be mounted within 24 inches of your radio so that its power cable can reach the radio power antenna lead.
How do I operate and preset the FM radio frequency on the PYLE VIEW PLMD7?
The PYLE VIEW PLMD7 FM Stereo Transmitter can operate from 87.7MHz to 88.9MHz (7 channel-200KHz Step).
The Frequency Selector Slide Switch is on one channel of the Transmitter and was set to 87.7MHz at the factory. Assuming it is still there, turn on the car stereo and select FM band operation. Tune the radio to 87.7MHz (depending on the frequency to which the installer has set the unit), or push the pre-set memory button.
The FM Station Frequency Selector Switch is located on the face and you may wish to change it after your initial checkout or sometime in the future.
What should I do if I experience interference on the PYLE VIEW PLMD7?
If interference is experienced on 87.7MHz, change the position of the frequency select switch on the face of the PYLE VIEW PLMD7 FM Stereo transmitter and tune the radio to the new frequency within the 87.7-88.9MHz range.
What frequencies are available on the Frequency Selector Switch for the PYLE VIEW PLMD7?
| Frequency (MHz) |
|---|
| 87.7 MHz |
| 87.9 MHz |
| 88.1 MHz |
| 88.3 MHz |
| 88.5 MHz |
| 88.7 MHz |
| 88.9 MHz |
What are the specifications for the PYLE VIEW PLMD7?
| Frequency | 87.7MHz to 88.9MHz (7 channel-200KHz Step) |
| RF Output Level | 60dBµ Max |
| S/N Ratio | 65dB |
| Stereo Separation | 40dB |
| FM Modulation Depth | 75KHz at L+R+Pilot |
| Operating Voltage | 10 V~16VDC |
| Dimensions | 44R X 23Hmm |
| Weight | 123g |
CLICK HERE TO DOWNLOAD PYLE VIEW PLMD7 (01) PDF DOCUMENT