PYLE HYDRA PLMRCAP200 (01) PDF Document

The PYLE HYDRA PLMRCAP200 is an energy storage device designed to supplement the audio amplifier’s power supply during high current demand, such as when music hits a low bass transient. It enhances the overall bass response of the audio system by storing a large amount of energy that can be discharged very quickly when needed. Additionally, it has the ability to filter car AC voltage induced by the amplifier’s power supply, which can otherwise cause audible noise in the car’s sound system.

The following warnings must be observed:

• This power capacitor may explode and cause serious injury or death if abused or connected improperly.

• Refer to the installation manual for correct procedures when making connections, and/or charging/discharging the capacitor.

• Do not expose the capacitor to voltages higher than specified at any time.

• Do not install in direct sunlight or extreme temperatures.

• Improper connection of this product can cause electrical damage to the vehicle and/or equipment.

For maximum performance, the digital power capacitor should be installed as close to your amplifier as possible. The ideal location is one that allows short wiring runs while keeping the capacitor somewhat isolated from the heat created by the amplifier system.

The positive power wire should be kept as short as possible and connected to the amplifier’s battery supply cable. It is recommended to use a high-performance distribution block to create a splice into this cable. The positive and negative wires to the capacitor should have the same gauge as the amplifier power wires. High-performance 8 or 10 AWG OFC power cables are a good choice.

The ground cable for the power capacitor should be kept as short as possible and should be connected directly to the vehicle’s chassis at a bare metal surface. Do not ground the capacitor directly to the amplifier ground terminal or ground cable.

No fuses should be installed in the wire between the power capacitor and the amplifier system. However, you must make sure there is an appropriate fuse at the battery in the main supply cable.

Connect the REM terminal to the automatic antenna connector of your car radio using 18 to 20 AWG primary wire. A cable diameter of 0.5 mm² is sufficient. When properly connected, turning your car radio on and off will automatically switch the amplifier and capacitor on and off.

1. Connect the power cable to the digital power capacitor. Connect the ground cable first and second the positive cable.

2. The digital PCB system will turn on automatically during the initial charging process. The status LED will light, and the decimal point display will flicker to indicate the system is charging the capacitor.

3. When the capacitor is fully charged, the decimal point display will stop flickering, and the display will show the DC voltage of the car’s electronic system.

If the DC voltage of the car’s electronic system exceeds ±0.1 ampere (for example, due to bass hits or high-consumption equipment causing voltage drops), the digital PCB will automatically operate. If the DC voltage does not exceed ±0.1 ampere, the digital PCB will maintain its “on” status for one minute to ensure stability and then automatically turn off and stay in “stand-by” mode. It will operate again if the voltage fluctuation exceeds ±0.1 ampere.

Yes. If the user accidentally reverses the polarity of (+) and (-), it can be harmful. The PYLE HYDRA PLMRCAP200 has a designed PCB relay inside to protect against incorrect connections. If connected incorrectly, the unit will not turn on, and a buzzer will warn the user. The capacitor will only turn on if all wiring is connected correctly.