PIONEER DDJ-WEGO2 (02) PDF MANUAL

When the application is launched, an audio engine is automatically configured to output the audio from Master and Monitor of DDJ-WeGO2. Please make sure that the audio device is properly set up.

1. Tap the settings icon to launch [Audio Device Setup].
2. Ensure that the name of the DJ controller connected to the application is displayed and the following channels are ticked:
• MAIN OUTPUT: Ch 1-2 / PIONEER DDJ-WeGO2 Audio Out
• PRE-CUEING: Ch 3-4 / PIONEER DDJ-WeGO2 Audio Out

If ticks are not shown, tap the appropriate options.

If the name of the DJ controller is not displayed, please ensure that the power of the DJ controller is turned on and try plugging the iPhone/iPad cable (Lightning) in and out of the jack of iPhone or iPad for several times.

Please follow the Operating Instruction of DDJ-WeGO2 to connect DDJ-WeGO2 and iPad or iPhone using the cable exclusively for use with this controller (Lightning). Then, connect a USB power adaptor and a USB mobile battery, both of which can be purchased separately, and launch the controller in the following steps.

1. Turn the power of DDJ-WeGO2. If the power has already been turned on, please turn off the power and then turn it on again.
2. Turn the power of an iPad/iPhone.
3. Launch djay 2 for iPad or vjay for iPad. “Pioneer DJ” logo appears on the screen.

• For further information about “djay 2 for iPad/iPhone” and “vjay for iPad/iPhone”, which are the paid versions of djay and vjay, please visit the website of Algoriddim. You can see the latest information on the requirements and supported devices on the website, too. (http://www.algoriddim.com/)
• For the customers who already have “djay 2 for iPad/iPhone”, “vjay for iPad/iPhone”, please update it to the latest version.
• Please ensure that the firmware of your DJ controller is updated to the latest version. You can download it from the URL below. (http://pioneerdj.com/support/)
• In order to connect and operate DDJ-WeGO2 and iPad/iPhone, you need a USB power adaptor and a USB mobile battery, both of which can be purchased separately, as well as the cable exclusively for use with the controller, which is included with it (Lightning).
• Please see the Operating Instruction of DDJ-WeGO2 for details.
• Please see the separately prepared “Hardware Diagram” for the functions controllable with DDJ-WeGO2.

If djay 2 for iPad/iPhone or vjay for iPad/iPhone cannot be controlled by DDJ-WeGO2, please remove the iPhone/iPad connection cable from your iPad, iPhone or iPod touch and connect it again.