PHILIPS TAH5209 (02) PDF Document

To charge your PHILIPS TAH5209 headphones, connect the supplied USB charging cable to the charging port on the headphones. A full charge takes approximately 2 hours.

To turn on your PHILIPS TAH5209 headphones, press and hold the power button for 2 seconds. The headphones will automatically enter pairing mode. The LED indicator will flash white and blue alternatively. To connect, open the Bluetooth settings on your device and choose “Philips TAH5209”.

You can control music playback using the buttons on your PHILIPS TAH5209 headphones:

Play/Pause: Press the power button once.

Next Track: Press and hold the volume up (+) button for more than 1 second.

Previous Track: Press and hold the volume down (-) button for more than 1 second.

To adjust the volume on your PHILIPS TAH5209 headphones:

Volume Up: Press the volume up (+) button once.

Volume Down: Press the volume down (-) button once.

You can manage calls using the buttons on your PHILIPS TAH5209 headphones:

Answer/End a call: Press the power button once.

Reject a call: Press and hold the power button for more than 1 second.

To use the voice and microphone features on your PHILIPS TAH5209 headphones:

Activate Voice Assistant: Press and hold the microphone button for more than 1 second.

Mute/Unmute Microphone during a call: Press the microphone button once.

To toggle the BASS mode on your PHILIPS TAH5209 headphones, press the BASS button twice.

To switch between connected devices using the multi-point feature on your PHILIPS TAH5209 headphones, press the multi-point button (indicated by a controller icon) twice.

To clear the Bluetooth pairing information from your PHILIPS TAH5209 headphones, press and hold the Bluetooth button for more than 5 seconds.

To reset your PHILIPS TAH5209 headphones to factory settings, press and hold both the volume up (+) and volume down (-) buttons simultaneously for more than 4 seconds.

The PHILIPS TAH5209 headphones comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Battery Information for EU Battery Regulation

Battery model no: WELL150040 (1ICP7/20/48)

Battery type: Li-polymer, 3.7V, 500mAh

Battery risk information: Do not insert incorrectly. Do not open or dismantle. Do not dispose of in fire. Do not short circuit.