OPTIMUM ATLICE ONE MINI (01) PDF MANUAL

OPTIMUM ATLICE ONE MINI (01) PDF SUMMARY:

How do I replace an Altice One Mini?

Make sure to return your old Mini within 15 days to avoid being further billed. For instructions, visit optimum.net/return.

---

What is the first step when replacing an Altice One Mini?

Connect the coaxial cable from your wall outlet to the “RF” port on the back of the Mini. Make sure the connection is finger tight.

---

What is the next step after connecting the coaxial cable?

Plug one end of the HDMI cable into the TV/OUT HDMI port on the back of the Mini and the other into one of the HDMI ports on the back of your TV.

---

What do I do after plugging in the HDMI cable?

Turn on your TV and make sure the input source matches the HDMI port you plugged the cable into.

---

When do I plug the Mini into a power outlet?

When you’ve reached an Agent, plug the Mini power cord into an electrical outlet.

---

What is the next step after plugging the mini into a power outlet?

Press and hold the power button on the front of the Mini and at the same time plug the other end of the power cord into the Mini.

---

What should I do after seeing the “Connect your box” screen?

Follow step 9A or 9B depending on your equipment.

---

When do I release the power button?

Release the power button when you see the “Software downloading” screen.

---

How long will it take for the Mini to configure?

Allow up to 10 minutes for your Mini to configure. It will turn on and off several times during the process.

---

What number should I call to start the activation process?

Call 877.851.5652 to start the activation process and wait for a Customer Care Agent before you proceed.

---

What should I do if I’m using my Mini with a Gateway?

If you’re using your Mini with a Gateway, press and hold the WPS button on the front of your Gateway for 5 seconds then release to put it into pairing mode.

---

What should I do if I’m using my Mini with Altice One?

If you’re using your Mini with Altice One, press the WPS button on the front of Altice One. You’ll see “WPS Pairing Mode” on the display when it’s in pairing mode.

---

What should I do at the Mini after putting the Gateway or Altice One in pairing mode?

Go to the Mini and press and hold the WPS button on the front for 10 seconds. The button will blink then turn solid white when the Mini is paired.

---

What should I do before I start replacing the Altice One Mini?

Press 7 and 9 simultaneously on your Altice One remote, then disconnect everything from your existing Mini.

---

What is the next step after disconnecting everything from the existing Mini?

Insert the SD card (included in the box) into the card slot on the back of the new Mini.

---

What should I do after inserting the SD card?

Wait a few minutes until you see the “Let’s Get Started” screen, then follow the on-screen instructions to complete the setup.