OMRON S8BA-24D24D480SBF (01) PDF MANUAL

To avoid electric shocks, please consult the dealer or a qualified professional for help when installing and repairing.

Please install and maintain the device by a professional electrician.

To avoid electric shock hazard, do not operate any connection or contact the terminal connector while the device is powered on.

Please do not touch the switch during use.

Install in a place where there is little dust, away from direct sunlight, corrosive gas and vibration.

Please keep the device away from heat source, such as hot heater.

To prevent fire, explosion or breakdown, please use a wire that supports the rated current of the device.

Do not drop or apply a strong impact to the device. Doing so may damage the internal components.

The product generates heat. If not ventilated, the product may cause breakdown. Make sure there is enough space for heat dissipation during installation.

Please use the specified power supply for this product, otherwise it may cause fire, electric shock or breakdown.

Do not connect the product to any equipment other than what is specified.

Be sure to turn OFF the power supply of the device before connecting or disconnecting the cables. Connecting or disconnecting cables while the device is powered on may cause electric shock.

Since there is a risk of electric shock, RISK OF injury and damage, and fire, DO NOT short-circuit the battery terminals.

Do not connect the device to a DC output or AC output of other device. Doing so may cause fire or electric shock.

Do not short-circuit the input or output terminal, it may cause electric shock.

Do not use in an environment that may allow liquid, metal chips or other foreign substances to enter the device.

If a foreign substance enters the device, immediately disconnect the power supply and contact your dealer.

Do not disassemble or modify the device. Doing so may cause electric shock or breakdown.

If the device is damaged, immediately disconnect the power supply and contact your dealer.

Battery is consumable. Please replace the battery when the battery warning indicator is ON or the battery cannot supply power.

Please do not short circuit the load terminal.

Do not use the device with a load that exceeds the rated output.

To avoid electric shock, always switch off the power supply before connecting or disconnecting the input/output cables for maintenance.

This product has a built-in battery. Even if the input power is OFF, there is still voltage at the output terminal. Please remove the battery or disconnect the battery cable before maintenance.

Do not throw the battery into fire. The battery may burst.

The battery contains lead. When disposing, please follow local regulations for disposal of hazardous materials.

Before using, to confirm the condition of the UPS, connect the input cable, wait for 5 minutes, turn OFF the UPS, turn ON the UPS and confirm it can normally boot, then disconnect the input cable. Confirm if the UPS can provide power through the battery.

After installing other devices than the UPS, check if the total right side of the current does not exceed the rated current.

During normal operation, the cooling fan may turn on sometimes. It is normal.

After receiving the product, please store the product at 0 to 40 °C (32 to 104 °F) and humidity below 90% RH (non-condensing).

When installing the device, please install on a flat and stable surface to prevent it from falling.

This product is a highly reliable device. However, considering system security, Omron recommends installing another highly reliable device as a backup.

This product is a product for a general environment that may cause radio interference. Please use the device in a suitable environment or take measures to avoid radio interference.