NOMA 052-7850-0 (01) PDF DOCUMENT

Before installing this product, familiarize yourself with all operating features and safety rules. Please read all instructions before assembling and using your new LED puck light kit.

IMPORTANT: FOR INDOOR AND DRY LOCATION USE ONLY. ADHESIVE TAPE MAY DAMAGE SURFACE IF REMOVED. Before installation, make sure the surface you intend to mount the product on is free of moisture, oil, grease, dust and dirt to ensure proper adhesion. Test painted surfaces.

Step 1. Mark the desired area where you want to install. Remove one side of the double-sided tape and secure it to the LED puck light. Then remove the other side of the tape and secure the puck light to your desired location.

Step 2. Remove one side of the double-sided tape and secure it to the sensor.

Step 3. Connect the puck lights to each other using the jumper cable connectors. Then connect the sensor to the desired location.

Step 4. Connect the plug-in adapter connector (A) to the puck light. Then connect the AC/DC plug-in adapter connector jack end (B) to the adapter connector round socket end.

Step 5. Affix self-adhesive wire guides to desired locations as needed to guide and secure jumper cables and the AC/DC plug-in adapter cord.

Step 6. Plug the AC/DC plug-in adapter into the power outlet. The LED puck lights are ready to be used.

Operate the light by using the IR remote controller with the following functions:

Power On button: Turns on the light.

Power Off button: Turns off the light.

Smooth Transition button: Changes LED colours gradually.

Jump Transition button: Colour jumps in sequence.

Up Arrow button: Increases the brightness of the light.

Down Arrow button: Decreases the brightness of the light.

Red button: Light will return to red.

WARNING: Prior to cleaning, always disconnect the plug from the electrical wall outlet.

1. There is no need to demount your LED Puck Lights when cleaning.

2. Always disconnect the plug from the electrical wall outlet before cleaning.

3. Dust or wipe with a damp clean cloth. Do not use solvents or abrasive cleansers.

4. To remove grease, use a mild soap like dishwashing liquid. Dissolve the dishwashing liquid with warm water. Using a clean cloth, wet and wring out excess water to wipe clean the LED Puck Lights and jumper cables.

5. Do not submerse LED Puck Lights and accessories in the water.

If your light does not operate, please check the following items before having it repaired:

WARNING: To reduce the risk of fire, electric shock or injury to persons:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CAUTION: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS:

1. Use only insulated staples or plastic ties to secure cords.

2. Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed into the wall.

3. Position the under-cabinet light with respect to the cabinet so the lamp replacement markings can be read during re-lamping.

4. Not intended for recessed installation in ceiling, or soffits.

5. Do not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cords behind walls, ceiling, soffits, or cabinets where it may be inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This device complies with ICES-003 of the IC rules; operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) This device must accept any interference received, including interference that may cause undesired operations.