Free English NEC NP3200 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD NEC NP3200 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I connect my computer to the NEC NP3200?
Connect your computer to the projector using the supplied VGA signal cable. Attach one end of the cable to the computer and the other end to the port labeled COMPUTER 1 IN on the NEC NP3200.
How do I connect the power cable to the NEC NP3200?
Connect the supplied power cable to the power input port on the NEC NP3200.
How do I turn on the main power switch of the NEC NP3200?
Locate the main power switch on the NEC NP3200 and set it to the I position.
What should I do after turning on the main power switch of the NEC NP3200?
Wait for the NEC NP3200 to enter standby mode. Once in standby mode, the POWER indicator will light orange and the STATUS indicator will light green.
How do I remove the lens cap on the NEC NP3200?
Simply grasp the lens cap and pull it off the lens of the NEC NP3200.
How do I turn on the NEC NP3200?
After ensuring the NEC NP3200 is in standby mode, press and hold the POWER (ON/STAND BY) button on the projector or the POWER (ON) button on the remote control for at least 1 second.
How do I select a source on the NEC NP3200?
Use the source selection controls on the NEC NP3200 or the remote control to select the desired input source.
How do I optimize an RGB image on the NEC NP3200?
Press the AUTO ADJ. button on the NEC NP3200 or the remote control to automatically optimize the RGB image.
How can I adjust the picture size and position on the NEC NP3200?
You can adjust the picture size and position using the lens shift dial and the zoom lever on the NEC NP3200. Please refer to the user manual for detailed procedures.
How do I use the lens shift dial on the NEC NP3200?
Rotate the lens shift dial on the NEC NP3200 to shift the image position vertically or horizontally.
How do I adjust the zoom on the NEC NP3200?
Move the zoom lever on the NEC NP3200 to adjust the image size.
How do I focus the image on the NEC NP3200?
Rotate the focus ring on the lens of the NEC NP3200 until the image is sharp.
How do I turn off the NEC NP3200?
Press the power button on the NEC NP3200 or remote control to initiate the shutdown process. Wait for the projector to enter standby mode, where the POWER indicator will light orange and the STATUS indicator will light green.
How do I turn off the main power switch of the NEC NP3200 after shutdown?
Once the NEC NP3200 is in standby mode, set the main power switch to the O (off) position.
How do I disconnect the NEC NP3200 from power?
After turning off the main power switch, unplug the power cable from the NEC NP3200.
CLICK HERE TO DOWNLOAD NEC NP3200 (01) PDF DOCUMENT