MAKITA CJ102D (01) PDF Document

	Read instructions.
	Not to be used by very young children (0-3 years).
	Do not insert pins.
	Do not dry clean.
	Do not bleach.
	Do not iron.
	Tumble dry with low heat.
	Machine wash, Gentle Cycle in water at Max. 30°C.
	Do not wring or twist.
	Line drying.
	Only for EU countries. Do not dispose of electric equipment or battery pack together with household waste material! In observance of the European Directives on Waste Electric and Electronic Equipment and Batteries and Accumulators, electric equipment and batteries that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility.

The heated jacket is intended for warming up the body in cold environments.

Children, handicapped persons, or anyone who are insensitive to heat, for example a person with poor blood circulation, shall refrain from using the jacket.

Do not use the jacket other than its intended use.

Never use the jacket when inside of it is wet.

Do not wear the jacket with bare skin.

If you sense anything unusual, switch off the jacket and remove the battery holder immediately.

Do not let the power cable be pinched. Damaged cable may cause electric shock.

If any abnormality is found, contact your local service center for repair.

Do not use pins or like. The electric wiring inside may be damaged.

Keep maintenance labels and nameplate. If they become unreadable or missing, contact your local service center for repair.

Choose appropriate temperature settings in accordance with the usage environment for continuous use.

The battery cartridge, battery and connectors must not be allowed to get wet during washing and drying.

The appliance is not to be used by young children unless the controls have been pre-set by a parent or guardian, or unless the child has been adequately instructed on how to operate the controls safely.

WARNING: In order to avoid the possibility of heatstroke, disconnect the clothing when moving to an environment having significantly higher temperature.

PAY ATTENTION: Check carefully on the marking in the internal part of the cloth. Do not insert pins on the cloth from external or internal parts.

When washing the jacket, follow the instructions in the caution tag on the jacket.

Before cleaning the jacket, remove the battery holder and the battery cartridge and then place the power cable in the battery holder pocket and close the fastener.

Recommended washing and drying time: Washing for 63 minutes (55 minutes washing and 8 minutes spin-drying) and low heat tumble drying for 30 minutes.

Do not expose the jacket to rain or wet conditions. Water entering the jacket may increase the risk of electric shock.

Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the jacket. Keep cord away from heat, oil, sharp edges.

Do not connect power source to USB port. Otherwise there is risk of fire. The USB port is only intended for charging lower voltage device. Always place the cover onto the USB port when not charging the lower voltage device.

Do not insert a nail, wire, etc. into USB power supply port. Otherwise a circuit short may cause smoke and fire.

Do not use the jacket if the switch does not turn it on and off. Any jacket that cannot be controlled with the switch is dangerous and must be repaired.

Maintain the jacket. Check for breakage of parts and any other condition that may affect the jacket’s operation. If damaged, have the jacket repaired before use.

Use the jacket in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the jacket for operations different from those intended could result in a hazardous situation.

If the fuse link has ruptured, return the jacket to our authorized service center for repairing.

When not in use, store as follows:

Allow it to cool down before folding.

Do not crease the appliance by placing items on top of it.

Examine the appliance frequently for signs of wear or damage. If there are such signs or if the appliance has been misused, return it to the supplier for any further use.

This appliance is not intended for medical use in hospitals.

Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.

Use the jacket only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.

Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.

Do not disassemble battery cartridge.

If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.

Under abusive conditions, liquid may be ejected from the battery; avoid contact. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight.

Do not short the battery cartridge:

1. Do not touch the terminals with any conductive material.

2. Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.

3. Do not expose battery cartridge to water or rain.

A battery short can cause a large current flow, overheating, possible burns and even a breakdown.

Do not store the jacket, battery holder and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F).

Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire.

Be careful not to drop or strike battery.

Do not use a damaged battery.

Follow your local regulations relating to disposal of battery.

Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.

Charge the battery cartridge with room temperature at 10°C – 40°C (50°F – 104°F).

Let a hot battery cartridge cool down before charging it.

Charge the battery cartridge once in every six months if you do not use it for a long period of time.

For an optimum life-time, the battery cartridge have to be fully charged, after use.

1. Power button

2. Battery holder pocket (Backside)

3. Power cable (Inside the battery holder pocket)

4. Hole for strap

5. Battery holder

Model	CJ102D/CJ103D
Temperature adjustment steps	3
Material	Outer shell: Polyester (94%), Spandex (6%) Inner shell: Polyester (100%)
USB power supply port	DC 5V, 2.1A
Operating time (h) (With battery BL1041B)	Low	APPROX. 14
	Medium	APPROX. 7.5
	High	APPROX. 4.0
Rated voltage (V)	DC 10.8 V – 12 V max
Battery cartridge	BL1016, BL1021B, BL1041B

Due to our continuing program of research and development, the specifications herein are subject to change without notice.

Specifications and battery cartridge may differ from country to country.

Operating time may differ depending on battery type and usage condition.

To turn on the jacket, push and hold the power button (about 1.5 seconds). To turn off, push and hold the power button again.

There are three temperature settings (high, medium, low). Three LED lights means that the temperature is set to “high”, two LED lights “medium”, and one LED light “low”. When you switch on the jacket, the temperature is set to “high”. Each press of the power button cycles through the jacket’s temperature setting.

(Only for battery cartridges with “B” at the end of the model number.)

Press the check button (7) on the battery cartridge to indicate the remaining battery capacity. The indicator lamps (6) light up for few seconds.

Indicator lamps			Remaining capacity
Lighted	Off	Blinking
			75% to 100%
			50% to 75%
			25% to 50%
			0% to 25%

NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity.

Hold the battery holder and the battery cartridge firmly when installing or removing the battery cartridge. Failure to do so may cause them to slip off your hands and result in damage and personal injury.

To install the battery cartridge (10), align the tongue on the battery cartridge with the groove in the battery holder and slip it into place. Insert it all the way until it locks in place with a little click. If you can see the red indicator (9) on the upper side of the button, it is not locked completely. Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the battery holder, causing injury to you or someone around you.

Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly.

To remove the battery cartridge, slide it from the battery holder while sliding the button (8) on the front of the cartridge.

You can either place the battery holder in the battery holder pocket or hang it on the belt.

In case placing it in the pocket: connect the battery holder and the power cable of the jacket and place it in the battery holder pocket.

In case hanging it on the belt: firstly pass the jacket’s plug through the hole inside the battery holder pocket, and connect the battery holder and the power cable of the jacket. Then hang the battery holder on your belt.

CAUTION: Connect only devices which are compatible with DC5V, 2.1A power source to the USB power supply port. Otherwise it may cause malfunction to the battery holder.

The battery holder (with the battery) can work as an external power supply for a USB device. Connect the USB cable (not included) with the power supply port of the battery holder. Then connect the other end of the cable with the device. Turn on the switch next to the USB port. The USB cable can be placed inside the jacket for convenience by using the hole of the pocket and cable holder.

NOTE:

Before connecting a USB device to the charger, always back up your data of the USB device. Otherwise your data may be lost by any possibility.

The charger may not supply power to some USB devices.

The battery power is consumed while the switch next to the USB port is turned on. Always turn off the switch when not in use.

CAUTION: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.

CAUTION: Always be sure that the jacket is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.

If the jacket does not switch on or any fault is found with a fully charged battery cartridge, clean the terminals of the battery holder and the battery cartridge. If the jacket still does not work properly, stop using the jacket and contact our authorized service center.

These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.

Makita genuine battery and charger

NOTE: Some items in the list may be included in the package as standard accessories. They may differ from country to country.