LG LB641122 (01) PDF Document

Any electrical installation work for the LG LB641122 oven must be carried out by a qualified electrician or a competent person. This electric appliance must be installed according to the instructions to avoid damage. The oven should be disconnected from the power supply before any installation or maintenance is performed. It is mandatory that this oven should always be earthed.

To install your LG LB641122 oven in a low cabinet, follow these steps:

1. Ensure the oven and kitchen cabinet dimensions match those shown in the installation diagrams.

2. The oven power supply must be located in the back area (P) of the kitchen cabinet or outside the installation space.

3. Depending on the power supply’s position, make a hole “P” in the back wall or a hole “R” in the side wall of the kitchen cupboard to pass the connection lead through.

4. Lift the oven using the side holes and slide it into the cabinet. Do not attempt to lift the oven by the front door handle.

5. Take care not to kink the wires of the electrical supply cable.

6. If you are also installing a hob, follow the hob installation instructions.

When installing the LG LB641122 oven in a high cabinet, please adhere to the following:

1. Refer to the diagrams for the correct oven and kitchen cabinet dimensions.

2. A minimum gap of 10mm must be maintained between the rear of the installed oven and the connecting wall.

3. To lift the oven, use the side holes as indicated in the diagrams.

4. The kitchen cabinet material that is in contact with the oven must be heat resistant up to 90 °C, and the fronts of close units must be heat resistant up to at least 70 °C.

For correct ventilation of your LG LB641122 oven, ensure the following requirements are met:

1. A ventilation opening of 50mm should be made between the back wall and the floor of the installation cabinet.

2. A ventilation gap of 5mm is required between the oven’s top rim and the cooktop’s lower rim.

3. A ventilation gap of 5mm is also required between both side rims of the oven and the cabinet.

4. These openings must not be closed or blocked in any way. Ensure the sides of the oven are not touching the front edges of the housing.

5. After ensuring proper ventilation and connection, secure the oven to the kitchen unit with screws.

The LG LB641122 oven must be connected by a licensed specialist in accordance with the installation instructions and in compliance with local regulations. Follow these guidelines:

1. Make sure the voltage shown on the rating plate is the same as the power supply voltage in your home.

2. Use a type H05 VV-F power cord.

3. The oven must be connected to the power supply by means of an all-pole disconnect switch with a minimum contact gap of 3mm and must be connected to an earthed socket by law.

4. The supply plug must be accessible after the installation is complete.

5. The oven’s components operate at 220-240V. Correctly identify the phase and neutral conductor in the socket. An incorrect connection may damage the oven.