LG LB641152 (01) PDF Document

Any electrical installation work for your LG LB641152 oven must be carried out by a qualified electrician or competent person. To avoid damage, this electric appliance must be installed according to the instructions. The oven should be disconnected from the power supply before installation or maintenance. The oven must always be earthed.

To install your LG LB641152 oven in a low cabinet, follow these steps:

1. Ensure your kitchen cabinet dimensions match the requirements shown in the installation diagrams.

2. The oven power supply must be located in the back area (P) of the kitchen cabinet or outside the installation space.

3. Depending on the power supply position, make a hole “P” in the back wall or a hole “R” in the side wall of the kitchen cupboard to pass the connection lead through.

4. Lift the oven using the side holes and slide it into the cabinet. Do not lift the oven by the door handle.

5. Take care not to kink the wires of the electrical supply cable.

6. If you are installing the oven with a hob, follow the hob installation instructions.

The required kitchen cabinet dimensions for a low cabinet installation are as follows:

Minimum Width: 560 mm

Minimum Height: 600 mm

Minimum Depth: 556 mm

Rear Ventilation Gap (Q R): A 50 mm opening is required at the bottom rear of the cabinet for ventilation.

To install your LG LB641152 oven in a high cabinet, follow these instructions:

1. Check that the kitchen cabinet dimensions meet the specified requirements.

2. A minimum gap of 10mm must be maintained between the rear of the installed oven and the connecting wall.

3. To lift the oven, use the side holes as indicated by the arrow in the diagram.

4. The kitchen cabinet material that is in contact with the oven must be heat resistant up to 90 °C, and any close unit fronts must be heat resistant up to at least 70 °C.

The required kitchen cabinet dimensions for a high cabinet installation are as follows:

Minimum Width: 560 mm

Height: 590 mm (within a range of minimum 575 mm to maximum 596 mm)

Minimum Depth: 556 mm

Rear Ventilation Gap: A 50 mm opening is required at the bottom rear of the cabinet for ventilation.

For correct ventilation of the LG LB641152 oven, the following is required:

1. A ventilation opening of 50mm should be present between the back wall and the floor of the installation cabinet.

2. A ventilation gap of 5mm is required between the oven’s top rim and the cooktop’s lower rim.

3. A ventilation gap of 5mm is required between both side rims of the oven and the cabinet.

These openings must not be closed or blocked in any way. Ensure that the sides of the oven are not touching the front edges of the housing.

The LG LB641152 oven must be connected by a licensed specialist in accordance with these instructions and in compliance with local regulations. Follow these steps:

1. Make sure the voltage shown on the rating plate is the same as the power supply voltage in your home (the oven’s components operate at 220-240V).

2. Use a type H05 VV-F power cord.

3. The oven must be connected to the power supply by means of an all-pole disconnect switch with a minimum contact gap of 3mm.

4. The oven must be connected to an earthed socket by law.

5. The supply plug must be accessible after the installation is complete.

6. Identify the phase (Live) and neutral conductor in the socket. An incorrect connection may damage the oven.

After you have connected the LG LB641152 oven to the power supply, secure the oven to the kitchen unit using the provided screws.