LECAVIST LCS155VN1ZPRO (01) PDF Document

The LECAVIST LCS155VN1ZPRO wine cabinet has specific conditions for its correct use:

• The appliance is intended for use in the home and similar environments only. It is not intended for commercial use.

• The appliance is not suitable for outdoor use or non-stationary installation.

• This wine cabinet can only be used to store various types of wines.

To avoid any potential hazards during the installation of your LECAVIST LCS155VN1ZPRO, you must follow these safety instructions:

• Observe all regional regulations for the installation of ventilation systems.

• During installation, maintenance, and repair work, the appliance must be disconnected from the mains electricity supply. It is only completely isolated when the mains circuit breaker is switched off, or it is switched off at the wall socket and the plug is withdrawn.

• Do not damage the refrigerant circuit.

• After the wine cabinet is installed, the plug must be easily accessible to facilitate its removal in case of an accident.

• THIS APPLIANCE MUST BE PROPERLY EARTHED. It is most important that this basic safety requirement is present and tested regularly. If there is any doubt, the household wiring system should be inspected by a qualified electrician.

• Do not pull the mains connection cable but the mains plug to disconnect your appliance from the mains electricity supply.

• Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead as they are a fire hazard and do not guarantee the required safety.

For safe cleaning and maintenance of your LECAVIST LCS155VN1ZPRO, please adhere to the following guidelines:

• The device must be cleaned regularly to prevent damage or the buildup of odors.

• Always clean the appliance exactly as indicated in the operating instructions.

• Always ensure the appliance is switched off before cleaning or replacing parts.

• There is a risk of fire if cleaning is not carried out as described in the operating instructions.

• Make sure no water penetrates inside the device when cleaning. Do not use a steam cleaning appliance, as the steam could reach electrical components and cause a short circuit.

• In areas subject to infestation by cockroaches or other vermin, pay particular attention to keeping the machine and its surroundings in a clean condition at all times.

Announced capacity: The advertised capacity is the maximum capacity calculated with a defined number of shelves which varies depending on the model. This standard is calculated with 75cl traditional Bordeaux type bottles. Any other type of bottle format as well as the addition of shelves will considerably reduce the storage capacity.

The main components of the LECAVIST LCS155VN1ZPRO are:

1. Control board

2. Inside fan

3. Sensor

4. Wire shelf

5. Adjustable feet

6. Hinge

7. Door seal

8. Glass door with anti-UV treatment

9. 10 Light LED on each side

10. Light LED on each side

Follow these instructions for proper installation of your LECAVIST LCS155VN1ZPRO:

1. Select a location with a flat and firm floor, and a well-ventilated room. The appliance is intended to be used at ambient temperatures ranging from 16 °C to 32 °C.

2. Remove the exterior and interior packing.

3. Before connecting to a power source, let the appliance stand upright for approximately 24 hours. This reduces the possibility of a malfunction in the cooling system from handling during transportation.

4. Clean the interior surface with lukewarm water using a soft cloth.

5. Place your wine cabinet on a floor that is strong enough to support it when fully loaded. Adjust the front leveling leg at the bottom to level the cabinet.

6. Ensure adequate ventilation. Do not block the front air outlet.

7. Connect the cooler to a single socket, leaving a 30-mm gap between the back of the cellar and the wall. Use a spirit level to ensure the wine cellar is perfectly level to prevent noise and vibration, and ensure the door seals perfectly.

The LECAVIST LCS155VN1ZPRO is designed to operate in ambient temperatures specified by its temperature class marked on the rating plate. The ambient temperature affects the interior temperature and humidity of your cellar. For optimal operation, the settings are carried out for ambient temperatures of 23°C to 25°C.

The control panel of the LECAVIST LCS155VN1ZPRO has several functions:

1. Temperature indicator light (15-20°C): If on, the setting temperature is between 15 and 20°C.

2. Temperature indicator light (9-14°C): If on, the setting temperature is between 9 and 14°C.

3. Temperature indicator light (5-8°C): If on, the setting temperature is between 5 and 8°C.

4. Light button: Press to activate or deactivate the light.

5. Temperature Display: Shows the set temperature. To display the actual temperature, press simultaneously on the temperature adjustment buttons (7) and (8). After 10 seconds, the display returns to the set temperature.

6. Temperature Unit Indicator: Shows the temperature unit in Celsius (°C) or Fahrenheit (°F).

7. Temperature Increase Button: Press to increase the temperature by one degree until the desired temperature is reached. The cellar temperature is adjustable between 5°C and 20°C.

8. Temperature Decrease Button: Press to decrease the temperature by one degree until the desired temperature is reached. The cellar temperature is adjustable between 5°C and 20°C.

9. Temperature Unit Button (°C/°F): Press for 3 seconds to switch between Celsius and Fahrenheit.

10. Power Button: Press for 3 seconds to turn the cellar on or off without unplugging it.

Press the light button (labeled with a lightbulb symbol) to adjust the lighting.

• Press the button until “L1” is displayed. This deactivates the automatic switching off of the LED lighting, and the light will stay on.

• Press the button until “L2” is displayed. This activates the automatic switching off of the LED lighting. The light will turn off after 10 minutes.

Vacation mode is available for observing certain religious holidays. This mode turns off the displays, interior lighting, and audible alarms and prevents them from turning back on. Normal cooling operations will still take place.

To activate Vacation Mode, press and hold the specified buttons simultaneously for at least 3 seconds. The indicator light will flash four times to confirm activation. To stop Vacation Mode, repeat the same button combination. The mode will automatically end after 96 hours.

The manual provides three different button combinations:

• Press the power button (10) and light button (4).

• Press the power button (7) and light button (1).

The Eco-Demo mode can be activated for presenting the device at exhibitions, trade fairs, or in sales rooms. In this mode, the compressor and all fan motors are off.

To activate Eco-Demo Mode, press and hold the specified buttons at the same time for at least three seconds. The indicator light will flash five times to confirm entry. To abandon Eco-Demo mode, repeat the same process. Note that the compressor and fan will activate 5 seconds later for compressor protection reasons.

The manual provides three different button combinations:

• Press buttons (4), (7), and (8).

• Press buttons (1), (5), and (6).

Your LECAVIST LCS155VN1ZPRO is equipped with an automatic defrost cycle. When a cooling cycle finishes, the appliance’s refrigerated surfaces are defrosted automatically. The defrost water is channeled into a condensates evaporation tray located in the back of the appliance near the compressor. The heat produced by the compressor then evaporates the condensates collected in the tray.

The winter function is a frost protection system that enables the cellar to operate in an environment where the temperature is between 5°C and 38°C. A sensor located outside the appliance triggers a low-power electrical element when the ambient temperature in the room falls to around 8°C. This element is designed to avoid sudden rises in the temperature of the wine and prevent thermal shocks that are damaging to its preservation. The system raises the cellar’s internal temperature even before there is a thermal exchange with the bottles.

While opinions and ambient temperatures vary, many people agree on the following serving temperatures:

• Prestigious Bordeaux wines – Reds: 16 – 17°C

• Prestigious Burgundy wines – Reds: 15 – 16°C

• Prestigious dry white vintages: 14 – 16°C

• Light, young, fruity reds: 11 – 12°C

• Provence rosés, primeur wines: 10 – 12°C

• Dry whites and vin de pays reds: 10 – 12°C

• Vin de pays whites: 8 – 10°C

• Champagnes: 7 – 8°C

• Sweet wines: 6°C

• Before cleaning, disconnect the appliance by removing the plug or by pulling the fuse on the circuit.

• It is recommended to clean the inside and outside (front, side, and top) with warm water mixed with a gentle cleaning product. Rinse with clean water and allow it to dry before reconnecting.

• Do not use solvents or abrasives.

• When the appliance is switched on for the first time, there may be a residual odor. In this case, run the appliance empty for a few hours at the coldest possible temperature to kill any odors.

• Most power cuts are resolved within a short time. A power cut of 1 or 2 hours will not affect the temperature in your cabinet. To protect your wines during a power cut, avoid opening the door as much as possible.

• During very long power cuts, take the necessary measures to protect your wine.

• If the appliance is disconnected or if there is a power cut, you must wait three to five minutes before restarting. If you try to re-start before this time, the compressor will only re-start after 3 to 5 minutes (if the temperature requires).

• When switching on for the first time or following a prolonged shutdown, it is possible that the selected and displayed temperatures are not the same. This is normal and will stabilize after a few hours.

To move your wine cabinet safely, follow these steps:

1. Remove all items.

2. Securely tape down all loose items (shelves) inside your appliance.

3. Turn the adjustable leg up to the base to avoid damage.

4. Tape the door shut.

5. Be sure the appliance stays secure in the upright position during transportation. Also protect the outside of the appliance with a blanket or similar item.

You can solve many common problems with your LECAVIST LCS155VN1ZPRO by trying the suggestions below.

Problem: Wine Cabinet does not operate.

Possible Cause: Not plugged in / Turned OFF. Tripped circuit breaker/ Blown fuse.

Possible Solution: Turn it On, or re-plugged the appliance. Check circuit breaker and fuse if working.

Problem: Temperature is not cold enough.

Possible Cause: Temperature control not set correctly. The door is opened too often or not properly closed. Damage or loose door seal.

Possible Solution: Reset temperature, wait a few minutes. Environment and weather may require a higher setting. Check the door for damages. Replace door seal.

Problem: Turns On and Off too often.

Possible Cause: Wrong temperature setting. Large contents added to wine cabinet. The door is opened too often or not properly closed. Damage or loose door seal.

Possible Solution: Reset temperature, wait a few minutes. Environment and weather may require a higher setting. Check the door for damages. Replace door seal.

Problem: The light does not work.

Possible Cause: Not plugged in/ Turned OFF. Tripped circuit breaker/ Blown fuse. The light button is “OFF”.

Possible Solution: Turn it On, or re-plugged the appliance. Check circuit breaker and fuse if working. Check and press the light button.

Problem: Vibrations.

Possible Cause: Wine cabinet is not leveled correctly.

Possible Solution: Check and adjust wine cabinet feet.

Problem: Making too much noise.

Possible Cause: As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant. Contraction and expansion of the inside walls may cause popping and crackling noises. The Wine Cabinet is not leveled.

Possible Solution: Some noise from the flow is normal. Check and adjust wine cabinet feet.

Problem: The door does not close properly.

Possible Cause: The Wine Cabinet is not leveled. Door is reversed and/or not installed correctly. Dirty door seal. Shelves are not placed correctly.

Possible Solution: Check and adjust wine cabinet feet. Choose an even/flat surface. Re-install the door. Replace the door seal. Position the seal correctly.

Problem: The code “HH” is displayed on the control board.

Possible Cause: Temperature is too high (>30°C) and an audible alarm sounds.

Possible Solution: Deactivate the audible alarm immediately by pressing the “ON/OFF” button or by unplugging the cooler. In this case, please contact the after-sales service.

Problem: The code “LL” is displayed on the control board.

Possible Cause: Temperature is too low (<0°C) and an audible alarm sounds.

Possible Solution: Deactivate the audible alarm immediately by pressing the “ON/OFF” button or by unplugging the cooler. In this case, please contact the after-sales service.

No, the appliance consists of light-emitting diodes (LEDs) that cannot be changed by the consumer. The lifetime of these LEDs is normally sufficient for no change to be made. If, however, the LEDs were defective, please contact your after-sales service for any intervention.

Electrical devices like the LECAVIST LCS155VN1ZPRO may not be disposed of in domestic waste at the end of their service life. They contain valuable materials and specific components that could be hazardous to human health and the environment if handled incorrectly. Please do not dispose of your old appliance with your household waste.

Dispose of these materials by contacting your local authorities and asking for the correct method of disposal. Please ensure that your old appliance poses no risk to children while being stored prior to disposal.