LAVA HEAT ITALIA WALL-E (01) PDF Document

Before assembly, unpack the LAVA HEAT ITALIA WALL-E and make sure that all items are present, with no components left in the box. Ensure that the heater head is free from any packing material.

Do not connect the heater to the electrical supply until the assembly is fully complete. Also, do not connect it to the electrical supply if any of the components or the power cord are damaged in any way. If you are in doubt, contact your supplier.

To assemble the LAVA HEAT ITALIA WALL-E, fix the heater on the pole by using the provided one piece of M6*10mm screw and fix it tightly.

Follow these guidelines for installing your LAVA HEAT ITALIA WALL-E:

General Placement:

• Mount the heater outside or in a large open area, well away from any obstructions like branches.

• The heater must be placed on a vertical and flat wall.

• The unit must be correctly installed according to the instructions, ensuring the head is at least 1.8m from the floor.

• The unit must be placed with a clearance of 180cm to the floor and 30cm to the ceiling.

Safety Distances:

• Keep it away from objects that can be affected by heat, such as furniture, curtains, or other inflammable objects (minimum distance of 1 meter).

• Generally, heaters must be placed at a safe distance (clear space) of at least 2.0m from combustible materials and glass walls.

• If installed in workshops or garages where inflammable or combustible paints are used, the heaters must be installed at a distance of at least 4.0m from the source of danger.

Prohibited Locations:

• Do not use near bath tubs, wash areas, or swimming pools.

• Do not use in unventilated areas.

• Do not use where gas, petrol, paint, or other inflammable goods are stored.

• It is not safe to use on a building site, greenhouse, barn, or stable where there’s flammable dust.

• Do not position the unit immediately above or below an electrical socket.

The LAVA HEAT ITALIA WALL-E requires connection to a 110V, 13 amp power supply that is located in a safe, dry area. The appliance must be earthed. It is important to ensure that the electricity supply has adequate capacity for the electrical load required by the heater.

To operate the LAVA HEAT ITALIA WALL-E, first connect the power cable to a 110V, 13 amp supply. The Pull-Off Switch is used to control the power of the appliance. Once the power is on, you can control the heat and light settings using either the PCB Hand Switch on the heater or the included remote control.

Using the PCB Hand Switch:

• Press one time: For LED lights.

• Press two times: For Heating Element.

• Press three times: For LED lights and heating element.

• Press four times: Turn off LED lights and heating element.

Using the Remote Control:

• The left button: For LED lights.

• The right button: For Heating element.

Always disconnect the power cable from the electrical supply when the patio heater is not in use.

Please adhere to the following safety warnings when using your LAVA HEAT ITALIA WALL-E:

General Safety:

• This appliance must be earthed.

• Disconnect the appliance from the 230V supply before installing or replacing the bulb, or before the lid is opened.

• Do not use the heater in particularly dusty and explosive areas.

• Do not push any items through, obstruct, or cover the grill of the heater head.

• Do not move the unit when it is connected to an electrical supply. Always wait for it to cool down before storing.

• Do not touch the heater head when it is in use, as it reaches high temperatures and stays hot for a period after being shut down.

• Do not leave the heater turned on and unattended, especially when children or animals are in the vicinity.

• Do not cover the unit with anything during operation or for a short time after it’s shut down.

• Do not wrap the power supply cord on the unit.

• The unit must be handled with care; avoid vibration or hitting.

Usage Restrictions:

• Do not use this unit as a cloth drier, towel drier, sauna heater, or room heater.

• Do not use this unit in place of animal propagating and rising.

• Do not use this unit if you are spray painting; it should not be used during painting operations.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities unless they have been given supervision or instruction.

• Children should be supervised to ensure that they do not play with the appliance.

For care and maintenance of your LAVA HEAT ITALIA WALL-E, please follow these steps:

• First, ensure the heater is disconnected from the electrical supply.

• Unplug the unit and wait until it cools before cleaning.

• Clean the outside of the patio heater with a damp cloth.

• Never use corrosive or solvent cleaners, and never immerse the unit in water.

• Any maintenance or repairs, including replacing the halogen tube, should only be carried out by a qualified electrician or by a recommended service center.

If the power supply cord is damaged, it must be replaced by an authorized agent or other professional people to avoid danger.

Yes, this is normal. Two dark points may exist on the surface of the heating elements during the first few minutes after it is turned on. This will not affect the performance of the unit.