LASERLINE SENOLITE 110 (01) PDF MANUAL

LASERLINE SENOLITE 110 (01) PDF SUMMARY:

What is the product?

The product is a laser receiver for red and green rotation lasers. It is called SensoLite 110 / SensoLite 110 G.

What are the parts of the laser receiver?

The laser receiver has the following parts: Marking track on all sides, receiver field for the laser beam, magnet, universal holder, fixing screw for measuring stick, battery compartment, switchover: fine range, freehand range, sound signal ON/OFF, ON/OFF switch, freehand range, fine range, hand receiver over laser level, exactly in laser level, hand receiver under laser level, sound signal ON/OFF, shows battery charge status.

How do you work with the laser receiver?

To work with the laser receiver, set the rotation laser to maximum speed and switch on the laser receiver. The laser receiver can now register the laser beam at a great distance. Move the laser receiver up and down through the laser beam until the screen display in the middle is shown. Now mark the measuring height on the rotating marking track.

How do you insert the battery?

Open the battery compartment and insert the batteries according to the installation symbols. Make sure the poles are in the right position.

What are the general safety instructions?

The device should only be used in accordance with its intended purpose and the specified specifications. The measuring instruments and accessories are not toys for children and should be kept out of their reach. No structural changes may be made to the device. Do not subject the instrument to mechanical stress, extreme temperatures, humidity or strong vibrations.

What are the safety instructions for dealing with electromagnetic radiation?

The measuring instrument meets the regulations and limit values for electromagnetic compatibility in accordance with EMC Directive 2014/30/EU. Be aware of local restrictions regarding operation, such as in hospitals, airplanes, gas stations, or near people with pacemakers. Dangerous interference or disruption of electronic devices is possible.

What is the universal holder for?

The laser receiver can be attached to leveling rods using the universal holder. The flexible measuring stick is recommended for all measurements at ground level. You can immediately calculate height differences without calculating.

What is the danger due to strong magnetic fields?

Strong magnetic fields can have harmful effects on people with active implants (e.g., heart pacemakers) and on electronic devices (e.g., magnetic cards, mechanical watches, precision mechanics, hard drives). With regard to the impact of strong magnetic fields on people, the respective national regulations must be observed, such as regulation BGV B11 §14 “Electromagnetic fields” from the professional associations in the Federal Republic of Germany. To avoid disturbing influences, the magnets must always be kept at a distance of at least 30 cm from the implants and devices that are at risk.

What are the tolerance ranges of the laser receiver?

The laser receiver has 2 tolerance ranges: Freehand range: Display with greater tolerance for rough positioning by hand. Fine range: Display with low tolerance for fine positioning (e.g. with a leveling rod).

What do the constant tone, rapid tone, and slow tone mean?

Constant tone = mark reference dimension; Rapid tone = Hand receiver over laser level; Slow tone = Hand receiver under laser level.

How do you maintain and care for the device?

Clean all components with a lightly dampened cloth. Avoid using abrasives, scouring agents, and solvents. Remove the battery/batteries before prolonged storage. Store the device in a clean and dry place.

What are the technical data for the device?

Laser receiver range max. 100 m; Power supply 2 x AAA 1.5 Volt batteries; Operating conditions 0 … 40°C, Air humidity max. 80% rH, non-condensing, Working height max. 4000 m.o.h.; Storage conditions -10 … 70°C, Air humidity max. 80% rH; Weight (incl. battery) 0.14 kg; Dimensions (W x H x D) 60 x 110 x 23 mm.

What EU requirements does the device meet?

The device meets all necessary standards for free trade within the EU. This product is an electrical appliance and must be sorted and disposed of accordingly in accordance with the European Directive on Waste Electrical and Electronic Equipment.