KNOLL CM24 (01) PDF Document

The ceiling mount center bolt for your KNOLL CM24 needs to be about 3 inches to the left (when viewing the screen) of the left to right center imaginary line from the screen.

Select a safe and secure position to firmly screw the square ceiling mount to the ceiling. It is NOT RECOMMENDED to use sheet rock or wall board with inserts to hold the projector and mount. Instead, screw the ceiling mount to a secure joist or use a 1/2″ painted wood butch plate that is secured to the joists, and then screw the ceiling mount to the butch plate.

After screwing the ceiling mount to the ceiling, thread the knuckle assembly onto the ceiling mount. With an allen wrench, slightly loosen the knuckle assemble screw.

Using the three supplied nylon spacers, mount the triangle shaped projector mount on the projector with the enclosed bolts and lock washers. Be sure to use the lock washers. Tighten the screws, but do not over tighten them.

Thread the projector mount (which is attached to the projector) onto the knuckle assembly (which is mounted on the ceiling mount) and spin the projector until it is tight. Spin the projector up to one more complete turn until it is facing the correct direction and the allen nut is also facing the screen.

Turn the projector on and horizontally and vertically adjust the projector until the image fills the screen. Tighten the knuckle assembly with the allen wrench. The projector may need to have its keystone adjusted so the image top and bottom fit on the screen.

Some jurisdictions require a second safety attachment on all ceiling mounted equipment. If this is the case in your area, add a secondary attachment. A popular method is to use a fishing leader from the projector’s adjustable foot to the ceiling.