KLEIN TOOLS BC515C (01) PDF Document

The contents and details for the KLEIN TOOLS BC515C are as follows:

1. Rail Hot Stick Holder

2. Rail Alignment Pins (x2)

3. Rail Alignment Pin Holes (x2)

4. Magnetic Cloth Cover

5. Magnet

6. Removable Spacer

7. Latching Tabs (x2)

8. Alignment Tabs (x4)

Read, understand, and follow these instructions to ensure safe operation. Failure to observe these warnings can result in property damage, serious injury or death. Keep these instructions for future reference.

1. INSPECT BEFORE EACH USE:

• Make sure all hardware is present and securely tightened.

• DO NOT use if there are signs of cracks, breakage or any other damage.

2. The KLEIN TOOLS BC515C Rail Hot Stick Holder is rated to hold a maximum evenly-distributed weight of 10 lbs. (4.5kg). DO NOT exceed.

3. Read and follow the warnings and instructions of the hot stick.

4. Always follow all DOT regulations including, but not limited to, securing loose items and covering the bucket during transport.

The symbols on the KLEIN TOOLS BC515C indicate the following:

• Warning or Caution: Indicates important safety information.

• No Tether Point: Not for Fall Arrest, Not for Dropped Object Prevention.

• Weight Rating: 10lbs (4.5kg).

• Magnet: Indicates the presence of a magnet.

The KLEIN TOOLS BC515C Rail Hot Stick Holder connects the corners of two Bucket Work Center wall panels.

NOTE: The KLEIN TOOLS BC515C ships with a Removable Spacer (6) preinstalled, intended for use with shorter 8′ (2.4m) hot sticks. If using with a longer 12′ (3.6m) hot stick, remove the Removable Spacer (6) prior to installation.

1. If installing the BC515C into an existing Bucket Work Center wall system, use a pair of Klein Tools lineman’s pliers to loosen the wall panel set screws on both adjacent wall panels, to assist in maneuvering the BC515C into place. If installing with a new set of wall panels, proceed to step 2.

2. Align the top of the Hot Stick Holder with one of the wall panels, then align the Alignment Tabs (8) with the gaps between the rails on the back side of the wall panel.

3. Using a rotating motion, slide the Alignment Tabs (8) into the gaps, until the Latching Tab (7) locks into place with the wall panel. You may have to lift up on the back edge of the Hot Stick Holder to assist the Latching Tab (7) in engaging.

4. Insert one of the Rail Alignment Pins (2) through the hole in the wall panel, into the Alignment Pin Hole (3) until the pin snaps fully into place. If necessary, lightly tap on the head of the pin to assist in engaging.

5. Align the remaining Alignment tabs (8) with the gaps between the rails on the back side of the second wall panel.

6. Lifting slightly on the back edge of the Hot Stick Holder, slide the wall panel toward the Hot Stick Holder, ensuring the Alignment Tabs (8) are properly aligned with the gaps between the rails on the back side of the wall panel, until the Latching Tab (7) engages with the wall panel.

7. Insert the second Rail Alignment Pin (2) through the hole in the wall panel, into the Alignment Pin Hole (3) until the pin fully snaps into place. If necessary, lightly tap on the head of the pin to assist in engaging.

8. Using a pair of Klein Tools lineman’s pliers, tighten all set screws on all wall panels to secure panels to bucket.

Yes, the following replacement part is available for the KLEIN TOOLS BC515C:

• BC515CRP Rail Alignment Pins (×2)

Clean the KLEIN TOOLS BC515C product with mild soap and water only. Rinse and wipe dry. Do not use abrasive cleaners or solvents.