IPEGA PG-QT03B (01) PDF Document

The main components of the IPEGA PG-QT03B are:

• Output connector

• Power indicator light

• On/Off button

• Type-C charging port

To charge the IPEGA PG-QT03B battery pack, follow these steps:

1. Connect one end of the Type-C charging cable to the original adapter, and the other end to the Type-C input port of the battery pack.

2. Plug in the adapter to begin charging.

When charging begins, all four LED lights will cycle once, then a single LED will blink to indicate that charging is in progress. The number of solidly lit LEDs indicates the battery level percentage (e.g., if two LEDs are solidly lit, the battery level is at 50%). When fully charged, all LEDs will be lit, indicating 100%. After unplugging the charging cable, the LEDs will turn off after approximately 38 seconds.

To charge your VR headset with the IPEGA PG-QT03B:

1. Insert the Type-C output cable from the battery pack into the Quest 2 (or Quest 3) VR headset’s input port.

2. The battery pack will automatically detect the headset and begin charging it.

The battery level of the pack will be displayed as a percentage (e.g., if three LEDs are solidly lit, the battery level is at 75%). As charging continues, the battery pack’s remaining charge will gradually decrease until the battery is depleted and requires recharging.

• If the LED lights are off, short press the power button once to display the current battery level and activate the output.

• To turn off the LED lights and stop the output, double press the power button.

• If the battery pack is not used for an extended period, it should be charged every three months.

• If the battery pack remains unused and uncharged for more than six months, it may experience deep self-discharge, making it impossible to recharge.

• The battery pack includes overcurrent, short circuit, and temperature protection. The battery cells comply with standard battery certifications.

• Do not disassemble or short-circuit the output end of the battery pack for extended periods, as this may cause irreversible permanent damage.

• Do not use chemical solvents to clean this product.

• Please do not store this product in damp or high-temperature areas.

• Avoid hitting, dropping, piercing, or attempting to disassemble the product to prevent unnecessary damage.

• The product contains electronic components such as batteries and capacitors and should not be disposed of casually. Please dispose of them properly by giving them to qualified recycling facilities.

The product list includes:

• Battery pack x 1

• Manual x 1

• Type-C cable x 1