HP SMART TANK 660 (01) PDF MANUAL

HP SMART TANK 660 (01) PDF SUMMARY:

What do the control panel buttons and lights indicate?

The control panel includes the power button, color copy button, black copy button, open lid light, attention light, Wi-Fi button/light, information button, resume button, and cancel button. The open lid light indicates when the scanner lid is open for copying or scanning. The attention light indicates problems with paper, ink, or printheads. The Wi-Fi light indicates the Wi-Fi status.

What media-related issues might occur?

These include out of paper and paper size/length mismatch, indicated by error codes E1/E2.

What do the error codes E3 and E4 indicate?

E3 indicates a print carriage jam or that the printhead cover is not closed. E4 indicates a paper jam.

What does the error code E7 indicate?

E7 indicates that the printer is out of ink.

What are the ink-related issues?

These include low ink and printhead-related issues. Note: Do not open the printhead cover unless instructed.

What is the Photo Copy mode for?

It is used for copying on photo paper.

What do the Wi-Fi Direct and Wi-Fi status indicators show?

They show the Wi-Fi Direct status, Wi-Fi status, and signal strength.

What are the printer features?

These include the ink access door, scanner lid, control panel, ink tanks, output tray, paper tray, power button, and removable dust cover (on some models).

How do I resolve the issue if the software is unable to find my printer during setup?

Check the following conditions:

• Printer Wi-Fi setup mode timed out: If the Wi-Fi light is off, the printer might not be in Wi-Fi setup mode. Restart Wi-Fi setup mode:

  1. If the control panel is not lit, press any button to wake the printer.
  2. Press and hold for 5 seconds until the control panel buttons light up.
  3. Press and hold and for 5 seconds until the Wi-Fi light blinks blue.
  4. Wait for one minute. Close and reopen HP software, and then try connecting again.

• Computer or mobile device too far from printer: Move your computer or mobile device closer to the printer, as it might be out of range of the printer’s Wi-Fi signal.

• Computer connected to a Virtual Private Network (VPN) or remote work network: Disconnect from a VPN before installing HP software. While connected to a VPN, you cannot install apps from the Microsoft Store. Connect to the VPN again after finishing printer setup. Consider your location and the security of the Wi-Fi network before disconnecting from a VPN.

• Wi-Fi turned off on computer (computer connected by Ethernet): If your computer is connected by Ethernet, turn on the computer’s Wi-Fi while setting up the printer. Disconnect the Ethernet cable temporarily to complete setup over Wi-Fi.

• Bluetooth is turned off on your computer or mobile device: Turn on Bluetooth for the computer or mobile device being used to complete printer setup. For mobile devices, turn on location services also. Bluetooth and Location services help the software find your network and printer. Your location is not being determined, and no location information is being sent to HP as part of the setup process.