GOLDENLINE TM3850T (01) PDF DOCUMENT

The specifications for the GOLDENLINE TM3850T are as follows:

The following parts are included with the GOLDENLINE TM3850T for assembly:

To mount the GOLDENLINE TM3850T wall plate on a concrete structure, follow these steps:

1. Use the included level (J) to position the wall plate correctly on the wall and mark the drilling locations.

2. Drill four holes using a 10mm (3/8″) drill bit to a depth of 60mm (2.4″).

3. Insert the concrete anchors (H) into the drilled holes.

4. Secure the wall plate to the wall using the four wall screws (G).

To mount the GOLDENLINE TM3850T wall plate on a wooden structure, please follow these instructions:

1. Ensure you are mounting into a wooden stud. Use the included level (J) to position the wall plate correctly and mark the drilling locations.

2. Drill four pilot holes using a 4.5mm (3/16″) drill bit to a depth of 55mm (2.2″).

3. Secure the wall plate directly into the wood studs using the four wall screws (G).

Yes, for mounting a Samsung TV with deep screw holes, you should use the included M8x45mm screws (K) along with spacers. The spacers should be provided by the TV manufacturer. Always check to ensure that the screw you intend to use is not longer than the depth of the hole in the television.

1. Select the appropriate screws (A, B, or C) that fit the mounting holes on the back of your television.

2. For a flat-back TV, attach the vertical mounting brackets using the selected screws with washers (D).

3. For a TV with a recessed or curved back, you may need to use spacers (E) between the bracket and the television. Place the spacers over the mounting holes and then secure the brackets with the appropriate screws.

4. Ensure all screws are tightened securely but do not overtighten.

Hanging the television is a two-person job. Follow these steps:

1. With one person on each side, carefully lift the television.

2. Align the hooks on the top of the vertical brackets (already attached to your TV) with the top rail of the wall plate.

3. Hook the brackets over the top rail and then gently lower the bottom of the TV until the bottom of the brackets rest against the bottom rail of the wall plate.

4. To secure the television, tighten the security screw located on the bottom of each vertical bracket. This will lock the TV in place on the mount.

After the TV is securely mounted, you can adjust the vertical tilt. The GOLDENLINE TM3850T allows for a downward tilt of up to 10 degrees and an upward tilt of up to 5 degrees. Gently push the top or bottom of the screen to achieve your desired viewing angle.

Please read all instructions carefully before installation. Adhere to the following safety precautions:

WARNING! This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.

• The mounting surface (wall, etc.) must be capable of supporting the combined weight of the mount and the television. If the structure is not strong enough, it must be reinforced.

• Safe installation requires at least two people.

• The use of protective equipment and proper tools is necessary.

• This product is designed for indoor use only. Using this product outdoors could lead to product failure and personal injury.

• Do not exceed the maximum load capacity of 50 kg. Exceeding the weight limit can result in damage to your equipment or personal injury.

• Do not use this product for any purpose other than its intended use.

Check the mount every two months to ensure that all moving parts are properly tightened and secure. This will ensure the continued safety and stability of your television installation.