Free English FUMEX MINITEX (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD FUMEX MINITEX (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the components of the FUMEX MINITEX MTI according to the exploded view?
The components of the FUMEX MINITEX MTI are numbered 1 through 6 in the exploded view.
What are the components of the FUMEX MINITEX MTF according to the exploded view?
The components of the FUMEX MINITEX MTF are numbered 3, 7, 8, and 9 in the exploded view.
What are the components of the FUMEX MINITEX MVK according to the exploded view?
The components of the FUMEX MINITEX MVK are numbered 3, 7, 10, and 11 in the exploded view.
What is the required torque for installation step 1 of the FUMEX MINITEX MTI?
The required torque for installation step 1 of the FUMEX MINITEX MTI is 10 Nm, using a T30 tool.
What is the required tool for installation step 1 of the FUMEX MINITEX MVK?
The required tool for installation step 1 of the FUMEX MINITEX MVK is an 8 mm wrench and a T30 tool.
What is the required tool for installation step 1 of the FUMEX MINITEX MTF?
The required tool for installation step 1 of the FUMEX MINITEX MTF is a T30 tool. The diameter is Ø4mm.
What tool is used in installation step 2 for the FUMEX MINITEX?
A T30 tool is used in installation step 2 for the FUMEX MINITEX.
What tool is used in installation step 3 for the FUMEX MINITEX?
A 13 mm tool is used in installation step 3 for the FUMEX MINITEX.
How is the coupling attached in installation step 4 of the FUMEX MINITEX?
In installation step 4 of the FUMEX MINITEX, first part A is inserted, followed by part B, and then part C is attached and secured with a tool.
How is the hood attached in installation step 5 of the FUMEX MINITEX?
In installation step 5 of the FUMEX MINITEX, first part A (the hood) is positioned, part B is inserted through the hood, part D is connected, and finally, part C is secured with a tool.
CLICK HERE TO DOWNLOAD FUMEX MINITEX (01) PDF DOCUMENT