FRANKLIN SPYDER PONG 54054X (01) PDF Document

The following parts are included in the Parts List:

Find a clean, level place to begin the assembly. It is recommended that two adults work together to assemble the product. Remove all parts from the box and verify them against the parts list. Carefully cut or tear the four corners of the box so the bottom can be used as a work surface.

Step 1: Slide the Table Top Tubes (#2) through the sleeves of the Net Table Top (#1).

Step 2: Connect the Table Top Tubes (#2) together by using the Middle Joints (#5) and the Corner Joints (#4).

Step 3: Fold over self stick net ends around end tubes and secure.

Step 4: Insert the Leg Tubes (#3) into the Corner Joints (#4) and Middle Joints (#5). Insert the Leg Caps (#8) into the Legs. If playing on grass, sand, etc., be sure the ground stake end of the cap is used for added stability.

Step 5: Flip table over. Insert Posts (#7) into the Middle Joints (#5). Slip Net (#6) sleeves around posts. Tighten velcro to increase net tension.

Spyder Pong: This game is played with (2) teams, consisting of either (2) or (3) players per team.

Spyder Pong Paddle Ball: This game is played with 2 players.

Teams are chosen amongst the group evenly. Flip a coin or volley for preferred service. Players should line up next to their teammate, but are free to move anywhere around the net once the ball is put into play.

Serve: A ball struck into the net from Team (A) to Team (B) to commence play.

Set: Volley between teammates to keep play alive or position to spike.

Spike: Aggressive striking maneuver when attempting to score.

1. SERVE IT! Teams should volley for serve to determine who goes first. The serve results from a player on Team A striking the ball overhand into the net for the player on Team B across from them. A “gentlemen’s serve” is suggested for normal play, where the ball must be easily returnable. Each point should begin with a serve.

2. SET IT! A served ball MUST be set to one’s partner, as it is illegal to spike a serve. A set is any strike of the ball that allows a volley to ensue. This is to set-up one’s teammate’s spike. For any consecutive rallies, the number of sets are optional, up the max of (3) hits total per team per turn.

3. SPIKE IT! Once your partner sets the ball to you, you are free to Spike the ball into the net. A good Spike will not be returned by the opponents and will earn you a point. Striking the Rim or a Clip is considered OUT, and results in loss of possession.

Only the team serving the ball is able to score a point during gameplay. A point is earned if the opposite team is unable to return the ball to the net at any time during gameplay.

The first team to reach 21 points wins the game. Keep in mind you can only score a point when your team is serving the ball. The team must win by 2 points. Optional games to 11 are allowed.

Shutout Rule: If a team reaches (9-0) during gameplay, the team with 0 points automatically loses.

If the team that’s serving the ball is the team that’s unable to return the ball to the net, the opposing team is then granted the following serve.

Teams have 3 hits amongst themselves to get the ball back to the net (the same number of hits allowed as normal volleyball). If they cannot do so, the opposing team is granted a point. No player can hit the ball twice in a row. Sets and spikes are both included when counting hits.

Once the ball is hit to the net by Team “A”, they must do everything in their power to grant Team “B” a fair chance to hit the ball back to the net.

ON A SERVE: If the ball doesn’t bounce cleanly off of the net to the opposing team during the serve, the serving team loses their turn and service is transferred to the opposing team. Rimmers lose a point and hitting the pocket (outside area where the ball doesn’t cleanly bounce) is a do over.