ECHO 99988805000 (01) PDF DOCUMENT

When using, filling, or washing the ECHO 99988805000 water tank, you should wear the following personal protective equipment:

– Industrial gloves

– Safety glasses

– Closed toe footwear

– Coverall

– Safety mask

Please follow these safety measures for safe operation of the ECHO 99988805000:

• Read the operator’s manual carefully before operating the equipment.

• Do not make modifications or adaptations to the equipment, as they can compromise safety and invalidate the warranty.

• Do not allow children, the elderly, people with disabilities, or animals near the equipment during use.

• Keep the equipment in good condition and in a safe place. Always wash and store the equipment without pressure.

• Wear the recommended personal protective equipment when using, filling, or washing the water tank.

• Keep connections tight to prevent leaks.

• Never fill the water tank with hot liquids; the maximum temperature is 30° C (85° F).

The main components of the ECHO 99988805000 are:

1. Tank

2. Schrader Valve

3. Complete Pump Assembly

4. Hose with quick connector

5. Pressure relief valve

6. Spring

7. Wheels

To pressurize the ECHO 99988805000 using the manual pump, follow these steps:

1. Unscrew the pumping tube and remove it from the tank.

2. Pour water up to the indicated level marked in the tank. Do not use chemicals in the tank.

3. Replace the pump tube and screw it tightly. The pump tube must be tight, otherwise the applicator will leak and not hold pressure.

4. Pressurize the unit by pumping the handle.

To pressurize the ECHO 99988805000 using an external air supply, follow these instructions:

1. Unscrew the pumping tube and remove it from the tank.

2. Pour water up to the indicated level marked in the tank.

3. Replace the pump tube and screw it tightly.

4. Remove the cap from the Schrader valve, which is located on the superior part of the tank.

5. Inject compressed air into the valve using an external air supply. The Schrader valve activates when the tank is full; you should inject air until the release valve activates.

6. Put the cap back on the Schrader valve. The water tank is now ready to be used.

To release the pressure from the ECHO 99988805000, you need to pull the release valve up with your fingers. Make sure you release all the air out before opening the tank.

To connect the ECHO 99988805000 to a concrete cutter machine, connect the quick connector of the pressurized water tank to the water inlet connection on the concrete cutting tool. Keep in mind the tank should always be pressurized while working. You can put the water tank on the ground.

The ECHO 99988805000 water tank requires minimum maintenance. Follow these service and storage instructions:

• At the end of your job, do not leave the water tank with pressure. Let all the pressure release through the pressure relief valve, then unscrew the pump handle.

• Always follow the instructions for use to avoid accidents and make the most of the product.

• Always store the water tank clean and empty in a dry place protected from the sun.

To keep your ECHO 99988805000 water tank in optimal condition, always keep the following parts greased: Piston sleeve, Pump tube o-rings, Plunger o-rings, and pressure relief valve o-ring. Use silicone-based grease for lubrication.

Follow these instructions for maintenance on the ECHO 99988805000:

1. Remove the pump tube from the tank and replace the o-ring located in the upper part. Lubricate before assembling.

2. Remove the screws of the pump tube and remove the handle. In the lower part, replace and lubricate the piston sleeve. Remove the check valve from the lower end of the pump tube and replace the o-ring.

3. Remove the relief valve to lubricate or change the o-rings if needed.