DUPLO DF-999 (02) PDF DOCUMENT

Before installing the DUPLO DF-999, please perform the following checks:

• Check that the power switch [A] is turned off before installation.

• Check that the voltage and frequency of the area in which this machine is used match the specifications on the label [B] pasted on the machine.

• When removing the machine from the container, lift the bottom [C] of the machine with two people.

Please note: A machine in the photos shown in the manual is a prototype. The colors and forms of the parts shown in the photos may be different from those of the production model.

Install the DUPLO DF-999 on strong, solid ground which can bear the weight of the machine. The weight is 43.0 kg/94.8 lb (This unit: 41.6 kg/91.8 lb, Accessories: 1.0 kg/2.2 lb).

The following installation space is required (width x depth x height): 1,112 x 512 x 554 mm / 43.78 x 20.16 x 21.82 inches.

Install the machine in a flat and stable place. Do not install this machine near heating equipment such as a stove.

The location must meet the following environmental requirements:

• Temperature range: 5 to 35°C, 41 to 95°F

• Humidity range: 20 to 80%RH (No condensation)

• No direct sunlight

• Outside light does not exceed 1,500 lx

• Little dust and dirt

• Little vibrations

• No salt

• No special chemicals

• No exposure to water

Make sure the power supply used is always within the following range:

• Power supply: 100 to 240 V, 50/60 Hz

When you power other appliances from the same wall outlet, make sure that the combined power consumption does not exceed the power supply capacity.

• Rated power: 100 W

• Rated current: 1.0 A to 0.5 A

No.	Name	Qty. (DF-999/DF-999A)	Qty. (DF-990/DF-990A)	Remarks
[u1]	Cross fold lever	1	1
[u2]	Auxiliary paper ejection guide	1	1
[u3]	Folding plate 1	1	1
[u4]	Folding plate 2	1	1
[u5]	Paper support guide	1	1
[u6]	T-handle hexagonal wrench	1	1	For User (tool)
[u7]	Scale label	1	1
[u8]	Power cord	1	1	For EU
[u9]	Power cord	1	1	For NA
[m1]	Instruction manual	1	1
[m2]	Safety Guide A	1	1
[m3]	DECLARATION OF CONFORMITY	1	1	For EU
[m4]	WEEE Statement	1	1	For EU
[m5]	Statement of Electromagnetic Compatibility (EMC)	1	1	For NA
[m6]	Installation manual	1	1	This manual

The DUPLO DF-999 is shipped with press release levers installed to avoid deformation of the folding roller. You must remove the press release levers when installing.

IMPORTANT: If the folding plate 1 is set before removing the press release lever, the folding plate 1 may become deformed or damaged. Be sure not to turn on the power before removing the press release lever.

Follow these steps:

1. Open the top cover [A].

2. Remove the tapes [B] that secure the press release lever.

3. Remove the press release lever 1 [C] in the direction of the arrow.

4. Remove the press release lever 2 [D] in the direction of the arrow, same as in step 3.

5. Close the top cover [A] that was opened in step 1.

For the complete installation procedures of the DUPLO DF-999, please refer to the instruction manual of this machine.

For setting the language to be displayed on the control panel, please refer to the service manual of the DUPLO DF-999.