DUPLO DF-990A (02) PDF DOCUMENT

Before beginning the installation of your DUPLO DF-990A, please perform the following checks:

• Check that the power switch is turned off.

• Check that the voltage and frequency of the area in which this machine is used match the specifications on the label pasted on the machine.

• When removing the machine from the container, lift the bottom of the machine with two people.

Please note that a machine in the photos shown in the manual is a prototype. The colors and forms of the parts may be different from those of the production model.

When selecting a location for your DUPLO DF-990A, ensure it meets the following requirements:

• Install the machine on strong, solid ground which can bear the weight of the machine. The weight of the DF-990A is 42.0 kg/92.6 lb (This unit: 40.6 kg/89.6 lb, Accessories: 1.0 kg/2.2 lb).

• The required installation space (width x depth x height) is 1,112 x 512 x 554 mm / 43.78 x 20.16 x 21.82 inches.

• Install the machine in a flat and stable place.

• Do not install this machine near a heating equipment such as a stove.

• The environment must meet the following conditions:

– Temperature range: 5 to 35°C, 41 to 95°F

– Humidity range: 20 to 80%RH (No condensation)

– No direct sunlight

– Outside light does not exceed 1,500 lx

– Little dust and dirt

– Little vibrations

– No salt

– No special chemicals

– No exposure to water

Ensure the power supply for the DUPLO DF-990A meets the following specifications:

• Power supply: 100 to 240 V, 50/60 Hz

• Rated power: 100 W

• Rated current: 1.0 A to 0.5 A

When you power other appliances from the same wall outlet, make sure that the combined power consumption does not exceed the power supply capacity.

The DUPLO DF-990A comes with the following accessories:

The press release lever is installed from the factory to avoid deformation of the folding roller. It must be removed during installation. Follow these steps:

Important: If the folding plate 1 is set before removing the press release lever, the folding plate 1 may become deformed or damaged. Be sure not to turn on the power before removing the press release lever.

1. Open the top cover.

2. Remove the tapes that secure the press release lever.

3. Remove the press release lever 1 in the direction of the arrow.

4. Remove the press release lever 2 in the direction of the arrow with the same as step 3.

5. Close the top cover that was opened in step 1.

For the installation procedures of the DUPLO DF-990A, refer to the instruction manual of this machine.

For the setting of the language to be displayed on the control panel of the DUPLO DF-990A, refer to the service manual of this machine.