DEWALT DCE042 (01) PDF DOCUMENT

The instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage:

DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

An icon without a word indicates a safety related message.

NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.

WARNING: To reduce the risk of serious personal injury, turn the unit off and remove the battery pack before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury.

The DEWALT DCE042 Tool Connect™ chip communicates with an optional application for your smart device (such as a smart phone or tablet) that connects the device to utilize the mobile application for inventory management functions. The Tool Connect™ chip is an Internet of Things device which is designed to be part of a connected asset management system.

NOTE: Do not remove the battery pull tab until instructed by the mobile application. The DEWALT DCE042 Tool Connect™ chip must be set up in the Tool Connect™ Site Manager application prior to installation. The chip does not function until setup has been completed in the Site Manager application.

1. Download the Tool Connect™ Site Manager mobile application from the App Store or Google Play.

2. Launch the Site Manager mobile application and follow instructions on adding a new Tool Connect™ new device.

1. Remove the retaining T10 Torx screws that hold the Tool Connect™ chip protective cover into the tool.

2. Remove the protective cover and insert the Tool Connect™ chip into the empty pocket.

3. Ensure that the Tool Connect™ chip is flush with the housing. Secure it with the retaining screws and tighten the screws to 0.3 Nm ±0.1 Nm. Do not overtighten.

The DEWALT DCE042 complies with Part 15 of the FCC Rules and Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

If this equipment does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

1) Reorient or relocate the receiving antenna.

2) Increase the separation between the equipment and receiver.

3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4) Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate the device.

When traveling on airlines, be sure to comply with the airline restrictions on usage of personal electronic devices and Bluetooth®.

The out of range alert feature has been designed to act as an aid to warn against products getting misplaced or stolen. It is not a security system.

The connectivity range is up to 100 feet (30.5 meters) depending on environment and location.

The shortwave radio frequency signals of a Bluetooth® device may impair the operation of other electronic and medical devices (such as pacemakers or hearing aids).

To comply with FCC and Industry Canada RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 5mm in the United States and 10mm in Canada from all persons and must not be co-located or operated in conjunction with any other antenna or transmitter.